It should be bolted to the engine block anywhere you can put it. Make sure it is on cast iron.
Disconnect the negative battery cable from the battery.
5/16" or 8mm
Disconnect the negative battery terminal for about 10 minuets.
Discconect the negative cable from the battery for a few minutes and that should do the trick
Battery first. Main Power fuse second. Bad Ground connection third. Ignition switch fourth.
disconnect battery
Take the negative battery cable off for 5 mins. Then put back on and go drive it a few miles.
check your regulator. it maybe over charging your battery
Yes, if it fits the holder.
Under your battery tray
Turn key OFF and just unhook the NEGATIVE battery cable for 5 mins and the computer will reset it's self.
Take out the battery, unbolt and remove the battery tray. This will expose where the ground is. Unbolt that. Replace in reverse order of the above steps.