It is located in the front driver's side of the engine bay connected to the vent canister. If you have a computer fault code related to it try cleaning the flow sensor that is just upstream of the valve. This thing gets filled with dust from the canister and causes the fault.
where is the purge control valve located on a 2000 grand am 4 cylinder
The purge valve is component to a vehicle's evaporative emissions system. For a 2003 Ford Ranger with the 2.3L L4 the vapor canister purge valve is Motorcraft part# CX2127. As of 2014 the wholesale cost for this part number is around 60$.
The 2003 Kia purge valve solenoid is located on the firewall in the engine compartment. The purge valve solenoid will be on the passenger side of the firewall.
Assuming this is a 4.3L engine, the canister purge valve is located on top of the engine on the drivers side towards the back.
A purge cylinder is a container used on the propane system. The cylinder aids in maintaining purity in gas lines.
locate it next to engine
On the 2.3 liter 4 Cyl, its located on the driver side near the battery. It is a brass colored metal cylinder and is connected via a vacuum tube to a black plastic canister, which is behind the driver side headlight.
Located on the drivers side next to the battery.
I think it is located in the engine compartment, not on the gas tank.
Looking underneath the battery compartment, locate two orange colored tabs. Those are located on the evap lines. Follow them to the purge valve which is held in with two screws.
above the rear end on the drivers side
The canister vent valve is located in back close to the fuel tank. The canister purge valve is located up front on the engine. If you're looking for the purge valve, look for a black plastic vacuum line under the hood that has a green dust cap on it. Follow that black line back to the engine. It will be connected to the purge valve.