Want this question answered?
The Yamaha Raider does not have a idle adjustment based on the fact it has no carbs. It is fuel injected and auto adjusts based on the temperature and fuel delivery.
I like cats.....
The idle adjuster screw on a 1984 Venture 1200 is shaped like a star. It is?ælocated on the left side of the carburetor and can be difficult to reach.
If it is a 650 it is behind the fuel petcock, on the left side of the bike under the tank.
There should be a screw near the end of the throttle cable on the throttle body.
Idle is computer controlled, no adjustment screw.Idle is computer controlled, no adjustment screw.
There is no adjustment screw, idle is automatically controlled by the pcm.
choke idle adjustment on 1988 Buick Riviera
As you are sitting on the bike, there is an idle adjustment screw on the left hand side of the carb about 1/3 of the way up on the slide. Turning the screw counterclockwise will slow the idle speed down on your bike and turning it clockwise will increase your idle speed ...Good luck
If the carburetor is cleaned on the Yamaha Bruin 350 and it will idle but stall when given gas, it could be that the float is sticking. The carburetor may also need to be adjusted by turning the adjustment screw so that it is not getting too much gas when revved.
under the seat where the throdle screws in the carb, there is an adjustment screw, turn right and it increases the idle. it worked for me. do it while running. It is a large flat head screw that is on the throttle body control mechanism. Not on the carburetor itself.
The idle adjustment screw is located on the IACV behind the manifold on a 1998 Honda CR-V. Open the latch on the IACV then take an screwdriver and tighten the adjustment screw.