The tach signal to the cluster is not on a dedicated wire. It comes over the CCD data bus. Which is a pair of wires that the computers on this vehicle use to transmit messages and information.
AnswerAt the PCM on the driver's side engine compartment. #7 gray wire on the black plug.
Your tach wire color is Gray. And it's located at Coil on passenger side of the engine. This goes for 1997 through 2001.
it's located at the bottom of the distributor
There are two gray wires at the black PCM plug, but only one of them is the ignition coil ground that you need to hook up to your remote starter. Neither will give you an A/C current.The correct gray wire goes into pin A7. If you remove the black plug and look at the front you will see all the pins are numbered.
Phillips screwdriver
sounds like a dead short in the tach wire, trace the tach wire and see if it the wire insulation has been broken.
tach signal wire is a blue wire with a black cap that ends on the top of the strut tower near the firewall...done
It depends on the year and options. Which year model are you asking about? On the 1996-2000 cluster, there's a light between the tach and speedometer for the cruise control (if equipped).
Are you talking about the dashboard 'glow' itself? That's not a light bulb, but a luminous panel that the dashboard information is printed on (things that don't move, like the speeds on the speedo or the revs on the tach). If that has gone out, you'll likely need to replace the entire dashboard...
theirs a green wire by distributer that is for the tach
IF you have the installation instructions for the tach, it prolly tells you where to attach the tach wire. If not, call the manu. of the tach or search for their website online.
yes