answersLogoWhite

0


Best Answer

IF you have the installation instructions for the tach, it prolly tells you where to attach the tach wire. If not, call the manu. of the tach or search for their website online.

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you install the tach wire for a tachometer for a '99 Elantra?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Where does a tachometer connect to on a Nissan 240?

on my tach, the green wire connects to the neg on the ign coil pack


How do you install an autometer tachometer on a 2003 Mitsubishi Eclipse and is it possible to connect through the coil-ignitor wires?

If you don't have a distributor on your car, you will need to get a tach adapter for your car. So that you can get an rpm signal from your car to the tachometer.Hey dude, here's how to connect the green wire from your tachometer: Tach output is obtained from PCM (powertrain control module) which is a 104 wire connector, and is located behind the passenger side kick panel. Look for pin number 48, which is usually an orange wire with a white stripe.(4.6L is = 4 ppr)Your best bet is to check out the autometer's web site which provides most all the information you might need. If you can't find the info email autometer tech support.Go to test connector inside the fusebox under the hood, it is a t-shaped plug. Tach is the terminal on the top left of the T. The wire under the terminal is white or white/red.


If you have a 2004 LeSabre without a tach can you swap this instrument cluster out with one with a tach?

It should work ok if the wire for the tach under the hood is connected and I don't remember which one it is.


How do you connect a tachometer in a 1993 Chevy S-10 2.8L?

green signal wire goes to the negative side of coil, not the positive. On your tach you probably have a ground(black),power(red), signal(green) and illumination(yellow?) wires. The signal wire splices into the positive side of the coil. The rest of the wires are pretty self explanatory. Make sure you have a solid ground and power. The illumination wire can be hooked into the headlight switch so it goes on with your lights. Tim The statement above is true for hooking up a tach. I just installed one in my 87 gmc s15. the trucks are set up from the factory to come with one, so you will find a wire located in the wiring harness that has a hookup for your tach. This is so you dont have to mess with the distributer set up. This may save you some time.


Installing after market tach on a 97 2.2L subaru legacy which wire on the coil pack?

the red one

Related questions

How do you install a tachometer on a 1997 Ford Crown Victoria?

pin 48 on the pcm connecter is tach signal connect to your green wire from tach


How do you install an aftermarket tachometer in a 92 Honda civic?

run it to the blue wire on your distributor. That's the tach lead.


How do you install a Sunpro super tach 2 tachometer in a 1994 Silverado?

hook your green wire from the tach to the white wire from the coil PAC it should be a white and a yellow wire coming from the coil. the tach should have a white wire that will be your light inside the tach a red wire for power and a black for ground.. good luck


Wiring diagram for 1979 trans am tach?

Tachometer Filter Tach Wire Plug Connector ON A 1979 TRANS AM


How do you install a Sunpro super tach 2 tachometer in a 95 acura integra?

you can install any kind of tach you want to in your car..if you do not have a stock tach then look in your manual for the rmp sensor wire..should be blue or green coming off the distributor...just splice into it...if you have a stock tach you can just splice into the stock tach wires by taking off the dash


Why would your 2005 Toyota tachometer stop working?

If the tach wire shorted or melted.


What color is the trigger wire on a 1989 Jeep Sahara tachometer?

On the 88 jeep the trigger wire at the tach is blue.


How do you install a tachometer into a 1996 Mitsubishi mirage?

hard to find the tach signal wire due to the fact that the ignition coils are built into the distributor (old cars always easy to work on) to get the right wire l have posted a page on how to install a tach to your Mitsubishi. go to www.sureyya.biz and click on Mitsubishi tacho install. Dont forget to give feedback on how useful the info was.


What is needed to install a tachometer in a dunebuggy with a 1970's vw motor?

a tachometer, wire and wire terminals


How do you install tach in 87 monty Carlo ss?

In order to install a tachometer on your 1987 Monte Carlo SS, you must first find the tachometer wire by using an automotive diagnostic tool. Mount the tachometer on the dashboard. Connect green, red, black, and white wires to the distributor, ignition power, cigarette lighter, and headlights, respectively. Turn on the engine to test if the tachometer works.


How do you install a tachometer in a 1991 Honda Civic and which wire is the coil wire coming out of the distributer?

its the blue wire, alot of ppl run it off the distributor, but why, when these cars came with a tach in the Si trim, just splice into the blue wire on the gauge cluster harness


How do you add a tachometer on a 1985 Chevrolet Caprice Classic?

On the distributor cap where the wiring hooks up is a terminal that says tach. Install the red wire to it and the black or ground wire to a suitable ground. Sometimes the tach has a green wire that connects to the white one coming from the ignition coil plug side that has 2 wires