Want this question answered?
It is problem with catalyst bank 2, catalytic converter, 02 sensor, pcv system, air leaks.
I have 2001 Mazda Tribute 4WD with 3.0 V6 and it uses timing chain, not a belt.
It's your 02 sensor.
The o2 sensor being referenced is located in the front end of the car underneath the cover with caution hand on it, the bank 2 o2 sensor is located behind the engine just before the catalytic converter.
where is the secondary 02 sensor on a 2004 crv
where is the 02 censor located
there are two oxygen sensors. One is located in the exhaust manifold inside the engine compartment. If you have a 4 cyl model it will be where the 4 pipes merge in to 1. The second sensor is located after the catalytic converter.
Trouble code P1507 means: Idle air control (IAC) underspeed error
a temp sensor is located on the intake or the thermostat housing
Bank 1 sensor 1 was the upstream 02 sensor located before the catalytic con on my 03.
29's here i have a 97 Mazda millenia 2.5 and have had the knock sensor replaced. all the Mazda 2.5 motors 95-02 are the same so i can tell you that its located in the center of the engine only accessible from the top of the motor underneath the intake and fuel rails (which have to be removed in order access the sensor). the gasket for the intake can not be reused and must be replaced. this a repair that a standard mechanic should be able to perform. hope this helps. It is underneath the supercharger support bracket on the 2.3L.
Cam sensor location 02 pontiac montana 3.4