On or near the engine . The engine is located under the hood.
where is the PVC fitting located at on the 2002 Nissan fronter with a supercharged 3.1 motor
Its not A PVC Its A PCV Value Its not A PVC Its A PCV Value
where is PVC valve located on 2002 Nissan sentra
On a lot of these vehicles, the PVC valve is located on top of the valve cover, or a hose leading from the valve cover to the intake. You have to remove the right front wheel. It will be in the block. It is in an awkward place and Nissan charges about a 100.00 to install it. You can do it your self though.
K-value is a measure of molecular wiight of PVC based on measurements of viscosityof PVC solution.
below the right side of carb.
between the oil filter and the alternator. on the right side (sitting in the drivers seat) of the engine. you must go thru the passenger front wheel well. pain in the rear
It's on the back of the intake plenum.
To change PVC valve on a 1993 Nissan 300zx, first remove the oil dip stick and remove the tension clip from the PVC valve hose. Then remove the hose and the old PVC valve. Replace with a new PVC valve.
It should be right on the valve cover somewhere.
on the right side of intake ,just below carb.