in the distribuator
Behind the passenger side cylinder head. It points down into the bell housing and reads off of the flywheel/flexplate.
The throttle position sensor on a 2000 Dodge Ram 2500 Diesel is located on the right hand side of the carburetor. This location is on the driver's side of the motor.
It is in the side of the block, behind the starter.
It is in the side of the block, behind the starter.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
Camshaft position sensor circuit malfunction.
Top of the bell housing, behind the passenger side cylinder head.
Below the injection pump, on the back of the timing cover.
The engine computer uses the crank position sensor for the tach reading. It is located in the top pass side of the bell housing.
The camshaft position sensor on a 95 Dodge 2500 3.9 is located inside the distributor, under the rotor.
No.
Reman will be around 2000-2500 for the partReman will be around 2000-2500 for the part