Look for it in the vicinity below the electrical house meter. There should be a bare wire coming out of the house in that area and if followed should take you right to the ground rod. There might be one 10' rod or two 6' rods. The wire will probably be buried just under the surface of the ground.
In a typical home electrical panel installation the main ground wire is connected directly from a ground rod driven into ground to a dedicated lug on the neutral bus.
The electricity from lightning will follow a wire from the lightning rod to the ground.
Any metal that will conduct electricity. Steel works fine, since it is strong. A ground rod driven into the ground and connected to the lightning rod with a wire or cable. The ground rod is usually copper clad (or plated) steel.
Yes. You can put it in horizontal position. Provided all other precautions are fallowed and it carries the electric current to earth. <<>> No, in North America a piece of pipe can not be used as a ground rod. An approved ground rod of 5/8" x 10 feet is what is required. If rocks are encountered and the rod can not be driven into the ground, the rod is substituted by a ground plate. Ground plates are becoming more popular as a backhoe can dig the hole for them in rocky soil. The ground plates also have the advantage of having a larger per square inch surface area than that of the required two ten foot ground rods.
5 feet
The ground wire should come from the ground rod and to the main electrical panel grounding terminal.
case of the ground
Ground bus in the panel.
In a typical home electrical panel installation the main ground wire is connected directly from a ground rod driven into ground to a dedicated lug on the neutral bus.
In case of a lightening strike.
Grounding is accomplished by connecting a heavy cable from the ground side of the antenna to a ground rod. A ground rod is typically a 4 - 8 foot copper plated steel rod driven into the ground as close as possible to the antenna, making the wire connection as short as possible. All equipment should also be grounded to a rod, not just the antenna.
To ground it. Washing machine build up a lot of static electricity.
The antenna becomes a lightning rod. By connecting the post it is attached to, to the ground via the metal rod driven into the ground, lightning will not pass along the antenna wire to your TV but will pass harmlessly through the post only.
EarthIts a earth groundat lower potential then your service
Connect other end to the ground lug in the service entrance part of your panel.
All electrical distribution systems require a system earth ground for personnel safety. The ground for your home electrical system is likely a grounding rod, a 10 ft. copper clad steel rod driven into the ground and then bonded with a brass clamp and large bare ground wire to your panel. This provides a path to ground to dissipate errant current which can occur due to a circuit which "shorts out." Better it goes to ground than into you!
The electricity from lightning will follow a wire from the lightning rod to the ground.