0
What else can I help you with?
When fixing a blown head gasket do you have to replace the manifold gasket on a 1991 Nissan pickup truck?
If it was removed then YES.
Where is the rear washer fluid container located on a 1991 Pontiac Transport?
Where is the rear washer fluid reservoir located on a 1991 Pontiac Transport
Where is the PCV valve located on a 1991 Pontiac Grand Am?
=== === === ===
How do you fix an exhuast manifold gasket on my 1991 celica?
Unbolt exhaust mainfold from cylinder head. Remove damaged gasket, clean surfaces well, but w/o scratching them. Put new gasket in place, and put exhaust manifold back. Torque bolts to spec - done.
Where is the knock sensor located in a 1991 Pontiac 6000 le?
In a 1991 Pontiac 6000 LE, the knock sensor is typically located on the engine block, often near the intake manifold or cylinder head. It may be positioned on the driver's side of the engine, mounted to the block. For precise identification, it's best to consult the vehicle’s service manual or a repair guide specific to that model.
Where is the voltage regulator located on a 1991 Pontiac sunbird?
8Where is voltage regulator located
Where is the exhaust manifold located on a 1991 Ford E-150?
its on the cylinder head. just like any exhaust manifold.
Where is the coil pack located on a 1991 Pontiac 6000?
On a 1991 Pontiac 6000, the coil pack is typically located on the engine, mounted near the ignition module. It is usually situated towards the rear of the engine compartment, near the intake manifold. To access it, you may need to remove some components or covers, depending on the specific engine configuration. Always refer to a repair manual for detailed instructions specific to your vehicle.
Where is the oxygen sensor location on 1991 Dodge Stealth?
they are located right at the exhaust manifold
Where is the PCV valve located on a 1991 Pontiac Sunbird V6?
on the valve cover
Where is the fuel pump located on a 1991 Pontiac Grand Am?
The fuel pump is located inside the gas tank.
How do you replace the thermostat located on a 1991 Pontiac Bonneville 3800?
I believe you want to drain the coolant, remove the top hose at the thermostat housing, remove the housing, replace the stat and gasket, reassemble fill with coolant and bleed the system.
