I found a place where I think it should be a relay on my 1996 Mazda 626. That was under the hood in the fuse box. Im searching to see if I really need a relay to make the AC work. I think that's why my AC isn't working.
will a 1997 Mazda 626 transmission or engine interchange with a 1999-2002 Mazda 626 transmission or engine
The 1995 Mazda 626 fuel pump relay switch can be found attached to the frame, next to the gas tank. The relay switch should be labeled as such.
The Mazda 626 turn signal relay switch can be found below the dashboard on the drivers side of the passenger compartment. The turn signal relay switch should be labeled as such.
The cooling fan relay on a 1998 Mazda 626 is located in the engine compartment near the firewall. It is housed in a protective box with latches.
on a Mazda 626 there is a fuel pump relay check to see if you have a power signal from the relay to the pump, if so make sure there is power to the pump.
The fuel pump relay on a 2002 Mazda 626 is located in the engine compartment on the driver's side. It is in a bank of relays just behind the battery location.
distributor or coil
The 1997 Mazda 626 starter is located near the back of the engine at the bottom. You can follow the positive battery cable from the battery to the starter.
You can adjust the camshaft on your 1997 Mazda 626 with the camshaft adjustment bolts. You can access the camshaft adjustment bolts by removing the cylinder heads.
On a 1988 Mazda 626, the fuel pump relay is located in the fuel tank. Always disconnect the battery before beginning work on a fuel system.
Mazda 626 1.8Ltr 1997-2002 Engine code FP Is an interference engine.
About two years.
On a 1997 Mazda 626 4-cyl, the (electric) fuel pump is located inside the gas tank.
its in the back of the rear left tire on top
Follow the red wire off the battery. Its a little box with wires coming out that run things such as lights and whatnot.
probably the fan relay
under left front of bumper
Should be on bottom of tranny.
The spark plug gap on a 1997 Mazda 626 DX should be set at .044 inches. A new spark plug will come preset from the factory.
I need a transmission for a 1997 626 Mazda 4 cylinder 3 speed automatic. What all transmissions will fit? I heard a Ford Probe tramsmission will fit. Is this true?
In the relay block in the drivers side engine compartment. The Relay labeled EGI Main.
how many belts are in mazda 626
In the fuse box.