0
Where is and how do you replace the modulator vavle on a 1975 dodge d-100 pickup?
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the modulator valve on a 1994 Mazda Protege DX?
where is the modulator vavle on my 1994 Mazda protege dx?
Where is the transmission solenoid of a 2005 dodge dakota?
It is inside the trans, on the vavle bodyIt is inside the trans, on the vavle body
Where is the egr vavle on a 92 Chevy pickup?
On the intake manifold, to the right (passenger side) of the Throttle Body.
Where is the transmission solenoid located on 1995 Dodge Dakota?
It is inside the trans, on the vavle body.
Would a bad modulator vavle make a 305 back fire at 3000 rpm It's a rebuilt 305 with a cam in a 84 cutlass?
the modulator is part of the transmission, more than likely you have a problem with timing. check your base timing, firing order, check your advance.
How do you replace a pcv vavle for a 1989 cougar?
pull the pcv valve out of the vavle cover grommet, pull the hose off of it, put a new one in, put the hose back on, yay!!
Your 1990 Chevy s10 will start but does not idle?
Possibly the IAC ( Idle Air Control) vavle on the throttle body, or egr vavle stuck open..........would check or replace IAC first, usually not expensive.
Where is the egr sensor located in a 2005 Dodge Magnum 3.5 L sxt?
The egr position sensor is part of the egr vavle.
Your 2004 dodge caravan is running rough and getting poor gas mileage engine light is flashing?
Check the EGR vavle
Where is the egr valve on a 2007 Dodge diesel?
The EGR vavle on a 6.7L is on top of the air horn on the intake on the driver side of the engine. The 5.9L does not have egr.
What does a thermo valve assembly on a Dodge Caravan do?
it is vacuum vavle controled by engine temperature. mostly used until engine gets up to normal operating temperature, or after the engine gets to normal operating temperature. depending on what is hooked up to the vavle. i hope this helps Answer your question.
Where is the PCV Valve located on a 92 Corsica?
on the valve cover as your faceing the car you will see a hose on the left side of the vavle cover. This hose goes to the intake plentum. the hose on the valve cover end goes to a connection that has a 19 mm nut screwed into the valve cover.loosen this nut remove the plastic cover and look in vavle cover. you will see the pcv vavle take a pair of needle nose and pull old pcv vavle out and replace.
