0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the backup switch located on a 1998 Ford Ranger 4X4?
It might be in the same place as a Ford Explorer... which is on the Transmission. Mine just went bad on my 1997 Explorer. You can order one from PepBoys for $50, or get them from an online store for $35.
What is the cause for airbag code 35 ona 00 ford explorer?
Passenger side air bag circuit low resistance or shorted
What is the fuel rail pressure on a 1991 Ford Explorer 4.0L?
35 to 45 PSI - key on / engine off ( According to my Haynes book )
What is the fuel pressure required for 1994 Eddie Bauer Ford Explorer?
35 to 45 PSI , with the key on / engine off , according to my Haynes book
Fuel pressure 1991 Ford Explorer 4.0 L?
35 to 45 PSI , key on / engine off , according to my Haynes repair manual
35 dollars in english pounds?
£21.25 without bank fees or fluctuation (correct as per 29 december 2013)
What is a relay on a car for?
A relay is a low voltage switch On my 1995 Ford Explorer I believe there are around ( 35 relays ) in various locations of the vehicle for various systems
How much pressure on a 1995 explorer gas pump?
For a 1995 Ford Explorer , with the 4.0 liter OHV , V6 According to my Haynes repair book ( 35 to 45 PSI with key on / engine off ) ( 30 PSI at idle )
How much is 35 dollars in english pounds?
£21.25 without bank fees or fluctuation (correct as per 29 december 2013)
How do you lower fuel pressure on a 2000 ford explorer xlt mine is 62 psi?
you probably need a fuel pressure regulator it should be around 35-45 psi
How old are you if you were born in September 1977?
At the time of answering (May 2013), 35 years.At the time of answering (May 2013), 35 years.At the time of answering (May 2013), 35 years.At the time of answering (May 2013), 35 years.
What is fuel pressure on 94 4.0?
For a 1994 Ford Explorer - 4.0 L : key on / engine off ( 35 to 45 PSI ) at idle with vacuum hose connected ( 30 to 35 PSI ) at idle with vacuum hose disconnected ( 35 to 45 PSI ) according to my Haynes repair manual
