Yes you did. Bank one Sensor one is the one next to the firewall on the exhaust manifold. You most probably need to get to it from beneath your car, as accessing it from the top may be nearly impossible.
The coolant temperature sensor on a 2001 Toyota RAV4 is located on the exhaust manifold. It is on the driver's side of the manifold.
that is the oxygen sensor on the exhause manifold.
under the intake manifold
its is located downstream on the backside exhaust manifold
the sensor is under the exhaust manifold at the rear of the engine
Your o2 sensors are on the exaust manifolds, if you slide under the truck with a flashlight and look up at th manifolds were they come out of the engine you will see each manifold has a sensor, also check with your Toyota dealer, because there was a recall on these sensors that melted in to the manifold. They replaced mine for free.
the 1999 Toyota corolla does not use a maf but it uses a MAP sensor located somewhere around the intke manifold
There are 2 catalytic converters on a V8 2002 Toyota Tundra. Bank 1 is the manifold and cat on the drivers side and bank 2 is the manifold and cat on the passenger side. Sensor 1 is the sensor on the exhaust manifold before the catalytic converter. Sensor 2 is the sensor located after the cat converter. Bank 2 Sensor 2 is the sensor located after the catalytic coverter on the passenger side.
A/F sensor are located in each exhaust manifold, O2 sensor After catalytic converter on exhaust pipe
O2 sensor in the exhaust manifold near the engine
The O2 sensor on a Toyota Corolla is located on the exhaust manifold. The O2 sensor properly reads the air fuel ratio to tell the engine how much fuel to use.
The oxygen sensor is located in the exhaust manifold before the catalytic convertor. If you look down between the radiator and the exhaust manifold a few inches before the exhaust pipe connects to the exhaust manifold you will see the Oxygen sensor. The sensor will have 2 wires coming from it and it kinda looks like a sparkplug stuck into the exhaust manifold. There is 2 nuts that hold the oxygen sensor into the exhaust manifold.