02 oxygen sensor circuit malfuction bank 1 sensor 1
Just in front of the Cat converter, drivers side.
Facing the car it is on the passenger side under the car after the cataylic converter
Try to picture this Bank 1 Sensor 1 Bank 2 Sensor 1 Catalytic Conv. Catalytic Conv. Bank 1 Sensor 2 Bank 2 Sensor 2
On exhaust, in front of each cat. convertor
The oxygen sensor for bank 1 sensor 1 for a 2000 mercury mountaineer is on the cylinder #1 side.
The HO2S (Heated Oxygen Sensor) bank 1 is between the manifolds and the Cadillac Converter. Manifold Exhaust (T) > "HO2S Sensor" > Cadillac Converter > muffler
bank 1 sensor 2 is after the cat
o2 sensor is on driver side 2nd one back
Bank 1 sensor 2 would be the sensor after the behind the catalytic converter.
Trouble code P0140means:O2 sensor ciruit-no activity detected (bank 1 sensor 2)
The 2000 Mazda Miata O2 sensor bank 1 is located on the firewall in the engine compartment. The sensor can be found on the passenger side of the firewall.
bank 2 sensor 2 location
bank 2 sensor 2 is the passenger side, rear sensor, it is located behide the catalytic converter.
That should be the sensor after the catalytic converter.
Bank 1 is the driver side.
That should be the sensor located after the catalytic converter.
Trouble code P0011 means:"A" camshaft postion-timing-over-advanced (bank 1)
Bank 2 is the side of the engine that faces the front of the vehicle, sensor 1 is the upper sensor, it is in the exhaust manifold
need change knock sensor 2 bank 2 in 2000 lexus rx300
Bank 1 is the passenger side of the engine in your 2000 Ford Mustang V6 Sensor 1 is before the catalytic converter ( upstream ) Sensor 2 is after the catalytic converter ( downstream )
2000 jimmy 4.3ltr v6. were is the o2 sensor bank 1, sensor 3
Bank 2 is the drivers side of the engine Sensor 2 is in the exhaust pipe after ( downstream ) the catalytic converter
BAnk one sensor one is above the cat on the back exhaust manifold. Sensor two is below the cat.
bank one is drivers side, sensor 2 is rear O2 sensor(oxygen sensors are screwed into exhaust pipes)