Sensor is available, Chrysler calls it a pick up plate.
The cam sensor on a 99 Buick Regal is located behind the rear cam bearing cap. It monitors the rotation of the cam and relays information to the vehicle's computer.
It can, but not always.
It has both, The crank sensor is on the timing cover passenger side behind the balancer. The cam sensor is the distributor, Inside of it.
there is no such thing as an egr position sensor
located behind cyl. head ,attached to the drivers side cam
p0341 is camshaft sensor A-bank 1 ckt range/perf, the cam sensor is bad or the wiring to it.
Yes
Crank sensor is on the driver side of the bell housing, Cam sensor is in the distributor. Computer is mounted to the inner fender.
Disconnect the battery. On the side of the throttle body, disconnect the wiring from the position sensor. Remove the bolts from the sensor, and lift the sensor off, reverse the procedure to install the new one.
The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate
I have a "99 F-350 super duty and my cam sensor is located: passenger side, front of engine, Look up from bottom just above cam shaft. close to bottom but up some. Wire plug in and little bracket