0
The cam sensor is mounted into the front timing cover just behind or near the water pump. Note that failure of the cam sensor to work properly is usually not cause by a faulty cam sensor but more commonly a failed permanent magnet located in the cam drive gear.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace a cam sensor on a 1990 lumina 3.1?
There is no cam sensor on a 90 3.1. Only a crank sensor.
1992 lumina apv 3.1 no spark changed distibtor coil relay the computer there are no crank no cam sensors timing is on what else could it be?
Bad coil? Bad distributor cap? If not HEI ignition-could be bad coil wire
Where is the 1992 Chevy 1500 pickup cam shaft sensor located?
1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.
Where is the cam sensor on a 1996 Chevy Lumina?
under neath the power stearing pump.
Where is the camshaft sensor on 1993 Chevy lumina euro?
There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!
Where is cam position sensor located on 1993 Chevy lumina?
Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.
What is the repair cost of 1992 Oldsmobile eighty eight cam sensor?
cam sensor cost around 28.00 if you put it in. Not hard one bolt.
Where is the cam sensor located on a 1992 Buick Park Avenue 3.8L?
IS CALL CAMSHAFT SENSOR AND IS LOCATED ON THE RIGTH SIDE OF THE ENGINE , ABOVE THE CRANK PULLEY You will have a crank sensor, but it won't have a cam sensor. it dose have a cam sensor, on the timing cover left sind of water pump
Where is the cam sensor on a 3.1 lumina?
I had to go to a dealership in order to find the location of the cam position sensor on a 1993 / 3.1 chevy lumina. I could order the part but was unable to find the location. after returning from the dealership. I am here to discredit those who say it doesn't have one. it in FACT does have one!. It is located under neath the intake plenum..
Where Cam shaft sensor 1992 riviera buick?
Both the CAM and Crank sensor are on the front of engine. The cam semsor is to the right and held in with two smaller screws. It is actually a sealed Hall Sensor device but pretty easy to change.
What is the sensor just above the starter on a 1997 lumina?
WOW WAY TO NAME ALL OF THEM LOL it is the crankshaft position sensor and either knocks sensor or camshaft position sensor First off if you a have a 3.1 it is the KNock Sensor. Crankshaft sensor and cam sensor is on the belt side of the motor. Crank is on bottom behind the big pully and cam is on top(half way up) usually under power steering pump
Where is the location of cam sensor on a 1992 ford ranger?
Some of the 1992 Rangers had the camshaft position sensor on top of the engine in the same hole where the distributor used to be. Some Ranger engines did not use a camshaft sensor at all.
