0
I had to go to a dealership in order to find the location of the cam position sensor on a 1993 / 3.1 Chevy Lumina. I could order the part but was unable to find the location. after returning from the dealership. I am here to discredit those who say it doesn't have one. it in FACT does have one!. It is located under neath the intake plenum..
What else can I help you with?
How do you replace a cam sensor on a 1990 lumina 3.1?
There is no cam sensor on a 90 3.1. Only a crank sensor.
Where is the cam sensor on a 1996 Chevy Lumina?
under neath the power stearing pump.
Where is the camshaft sensor on 1993 Chevy lumina euro?
There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!
Where is cam position sensor located on 1993 Chevy lumina?
Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.
Where is cam sensor on 1992 lumina apv 3.8?
The cam sensor is mounted into the front timing cover just behind or near the water pump. Note that failure of the cam sensor to work properly is usually not cause by a faulty cam sensor but more commonly a failed permanent magnet located in the cam drive gear.
Where are the three oxygen sensors located on a 1996 Chevrolet Lumina 31?
where is the oxygen sensor located on a 1997 Chevrolet lumina
Crankshaft sensor for a Chevy Lumina?
Where is the crank sensor on a 95 chevy lumina car ?
What is the sensor just above the starter on a 1997 lumina?
WOW WAY TO NAME ALL OF THEM LOL it is the crankshaft position sensor and either knocks sensor or camshaft position sensor First off if you a have a 3.1 it is the KNock Sensor. Crankshaft sensor and cam sensor is on the belt side of the motor. Crank is on bottom behind the big pully and cam is on top(half way up) usually under power steering pump
Where do you find the knock sensor in a 1999 Chevy lumina?
Where do you find a knock sensor on 1999 Chevy lumina
Does a Chevrolet 2.2 have a cam position sensor?
The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.
How do you change cam sensor on 1997 chevy Lumina?
To change the camshaft position sensor on a 1997 Chevy Lumina, first disconnect the negative battery cable for safety. Locate the sensor, which is typically positioned near the engine block, and unplug the electrical connector. Remove the mounting bolt(s) securing the sensor, then take out the old sensor. Install the new sensor in reverse order, secure it with the bolt(s), reconnect the electrical connector, and finally reattach the battery cable.
Where are the timing marks on cam gear on a 3.1v6 Chevy Lumina 91?
the timing marks are not on crankgear on cam gear Chevy Lumina 3.1 1995 would it be keyway to keyway
