It is mounted on the front side of the transmission, It will have a black plastic line coming from it and going up to the clutch master cylinder.
should be located on the bell housing
The clutch slave cylinder , for a hydraulic clutch , is inside the manual transmission bellhousing
The hydraulic clutch slave cylinder is inside the manual transmission bellhousing
The slave clutch cylinder on a 1994 Honda Civic is located inside the engine compartment. On the driver-side close the firewall. The clutch fluid should be drained. Remove the mounting bolts and clutch lines to replace the slave clutch cylinder.
Most of the time it is because of a bad slave cylinder that does not hold pressre or is leaking. They use brake fluid and to check them look at the CLUTCH MASTER CYLINDER near the firewall.
if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.
under the car ... near the clutch housing .... you cant miss it
Remove clutch cable connection and then remove slave cylinder line from master. Then unbolt slave master and remove it. Follow same procedure in reverse order.
The part tat goes where the tramison
It is under the battery tray on the bellhousing for the tranny.
Napa Auto parts for around $52.00 for the line for the slave and mater assembly around $200.00
The slave cylinder is in essence a hydraulic throw-out bearing. It encompasses the input shaft so you need to drop the transmission to get to it.