Check along the top of the radiator support (just behind the grille). They used to hide them there once in a while. Also try under the seat, but depending on the year, just unscrew the wingnut on the bracket and drop the spare on the ground.
crank tool is in clips along the top of the frame in front of the radiator,under the hood
What position is the crank sensor on a f250 ford pickup
If there is no faster head visible then it likely is attached with a clip on the backside of the crank handle. slip the handle between the handle and door panel to remove the clip.
On a 1998 Ford F-150 : The jack handle should be at the front of the engine compartment , on top of the radiator support
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
How to Remove or Install Car Window Crank Handles check related link below
with the jack handle their a hole in the bumber to slide the handle in to the tire crank mec.
No it does not have a crankshaft sensor, the engine control module uses the distributor for crankshaft position.
"Handle runs across the radiator support, jack should be on the firewall."
If it has a distributor it doesnt have a crank position sensor. The magnetic pickup in the distributor is what you would be looking for. The module is either on the side of the distributor or on the firewall against the drivers inner fender.
On my 1995 Ford Explorer , I fold the right rear passenger seatback forward and lift a panel that is located just behind the backrest . The rod ( 2 sections ) for the jack and lowering the spare tire is held in place by clips , the lug nut wrench / jack handle is behind the plastic access panel in the drivers rear of the cargo area
where is the VIN located on a 1937 ford pickup