Underneath the fuel filter housing.
how do you replace a fitting from a high pressure oil pump that is leaking oil in a 2001 ford F350 diesel truck?
it is inside the high pressure pump, which deals the diesel
check out www.powerstroke.org/forum/6-0 motor-problems/67527-high-pressure-oil-pump-04 high pressure oil pump 04 6.0 ford powerstroke diesel forum
What steps are needed to change a high pressure oil pump ona 03 6.0
Overheating and high boost pressure typically are signs of an EGR problem.
symptoms of high engine oil pressure
ebay are doing one for £125 both the high pressure and return side. also high pressure side for alot less if you model is 2001 +. hope this helps
High pressure Diesel Injection
The problem is a leak inside the high pressure oil system. When it is hot the leak expands and causes the truck to not start.
The compression on the cylinders of a 2001 Holden Rodeo diesel 2.8lt is not stated. It is stated that the 2001 Holden Rodeo diesel 2.8lt has a high compression g200z motor.
the high pressure oil pump supplies the oil to the rails mounted over the injectors in the valve covers and there is two sensors that control the pressure ipr and ipc located on pass side valve cover the ipr is behind the turbo in the high pressure pump cover
It is located on the top of the HPOP High Pressure Oil Pump center of engine in back by firewall. Takes a 34mm flat wrench or a handy dandy ford cut out socket.