0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where do you put hydraulic fluid in a Massey Ferguson 290?
To the left of the gear shift lever, large plug on top of transmission. Fill here,
Where do you put oil in a Massey Ferguson 231?
A MF 231 holds about 9 gallons of hydraulic oil and is added via a plug in top of the transmission housing.
Where do you put hydraluic oil in a Massey Ferguson 231?
A MF 231 holds about 9 gallons of hydraulic oil and is added via a plug in top of the transmission housing.
Where do you put hydraulic fluid in a Massey Ferguson 240?
Just to the left of the shift lever is a large plug. It resembles about a 1 inch hex head with a 1 1/2" washer beneath but it is actually just a one-piece plug. Hydraulic oil goes in there.
What is the wiring diagram for the alternator on a 1969 175 Massey Ferguson?
how do you hook up a alternator on a 175 Massey Ferguson tractor with tach drive on it the plug has been cut off..
Where is hydraulic fill on international 460 utility tractor?
The hydraulic fill is a pipe plug just to the left of the shifting lever as you sit on the tractor.
How do you tell if hydraulic jack needs fluid?
Remove the fill plug and top it off with hydraulic oil.
Where is the fill hole located on the 1995 lebaron convertible hydraulic motor?
there is a rubber plug on the top portion of the motor .remove the plug,fill and put plug back on
Where do you check and fill the hydraulic fluid on a Leyland 262?
Hydraulic fluid ?? P/Steering, Plug in top of pump on side of motor at front of motor Hyd/Remotes, Gear box dip stick and fill behind seat, large cast plug ??
What type of hydraulic oil is used in Massey Ferguson 65?
You may use two different hydraulic oil 1st is a 80-90 hydraulic oil available at the same store, also the recommended orginally was a mineral oil 90w . I have found both of these at your local tractor supply stores. The mineral oil is the least expensive running about $16.99 for two gallon container. The mineral oil will say on it for Ford 1952 through the 1960 years. It is the same again as the orginal mineral oil specified in the service manual. Both of these oils fill the transmission combination rear axle and hydraulic. There is one fill hole as you set on the drivers seat and look down at the left side of shift handle about 5 inches over you will see the hex headed plug for filling. The dip stick is on the right side below the hydraulic handles and at about heal level above the running board again as you set on the seat. There is a hole passage way that connects the transmission differetial hydraulic together about 32 quarts of oil is needed to fill don't forget to check and don't over fill. Check this level occasionally especially if you are leaking some around the pto shaft output.
How to refill engine hoist hydraulic cylinder?
Most hydraulic ram cylinders should have a refill plug about half way up the barrel. 1) Position the cylinder vertically, and collapse the ram all the way down. 2) With the plug pulled out, fill the cylinder with hydraulic jack oil until it drips out the plug hole. 3) All done. Place the plug back in and test the functionality.
Where is the hydraulic oil fill on a Ford 3930 tractor?
On the housing there is a plug and you take it off and put ameba muti g 134 oil in it
