0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What type oil is used in the Massey Ferguson 65 hydraulic system?
sae 90 gear oil. it is 100% mineral oil. napa, car quest, call your local massey dealer they have it. you will pay a little more but they have all the answers.
Engine torque settings for Massey Ferguson 202 tractor?
Am looking for a toy Massey Ferguson 65 in the 1/16 or1/43 size. Can anyone give me so help in locating one. It is for a 90 year old retired farmer. Thank you. Teer@Iowatelecom.net
What type of transmission oil or fluid and how does a 1962 Massey Ferguson Super 90 use.?
Use only Honda ATF! Your Honda dealer will have the proper fluid.
What type oil in transmission on Ferguson 30?
If it is a ferguson TO-30 it takes about 6 gallons of GL-1 90 weight gear lube (mineral oil). It is one big resevoir that lubes the transmission rear end and runs the hydraulic lift arms. Be careful because you dont want to put regular gear oil in there because it is too heavy and the sulfer in it will attack the bronze.
Does a 350 from a 90 Sierra Z71 have hydraulic or solid or roller lifters?
hydralic
What type of hydraulic oil is used in Massey Ferguson 65?
You may use two different hydraulic oil 1st is a 80-90 hydraulic oil available at the same store, also the recommended orginally was a mineral oil 90w . I have found both of these at your local tractor supply stores. The mineral oil is the least expensive running about $16.99 for two gallon container. The mineral oil will say on it for Ford 1952 through the 1960 years. It is the same again as the orginal mineral oil specified in the service manual. Both of these oils fill the transmission combination rear axle and hydraulic. There is one fill hole as you set on the drivers seat and look down at the left side of shift handle about 5 inches over you will see the hex headed plug for filling. The dip stick is on the right side below the hydraulic handles and at about heal level above the running board again as you set on the seat. There is a hole passage way that connects the transmission differetial hydraulic together about 32 quarts of oil is needed to fill don't forget to check and don't over fill. Check this level occasionally especially if you are leaking some around the pto shaft output.
How much oil and what type is in Massey-Ferguson 50 gas tractor?
1.) Buy yourself an MF 50 tractor Owner's Manual. Try your local Massey Ferguson dealer or search online. Places like eBay and such are good places to try for used manuals. 2.) Go to Tractor Supply Co. and buy yourself an I&T Service Manual. (They are cheaper than the OEM MF manuals, but are not as comprehensive, and are more geared towards mechanics.) Also, it depends on what you are talking about. - The Hydraulic System? - The Engine? (...and is it a gas or diesel)? - What climate do you run the tractor in? Cold? Temperate? Hot? Generically speaking: - Engine - Regardless of temp, for most climates, you can run 10W-30 in the engine safely, no matter what. Cold? (0-60 degrees F) 5w-30 or 10w-30 or SAE 10 Temperate? (30-90 deg F) 10w-30 or 10w40 (or 15w-40 if diesel) Hot? (60-120 deg F) 10w-30 or 15w-40 or SAE 30 - Trans & Hyd - I believe the MF 50 uses a "common-sump" transmission/hydraulic system. Therefore, any good quality modern Transmission AND Hydraulic Fluid can be used. Honestly, even if they were separate sumps, you still could use the same fluid in this case. Fluids commonly known as: - TH fluid - Universal Tractor Hydraulic AND Transmission Fluid - John Deere's: HY-Gard J20C - Case IH's: HY-Tran - Massey Ferguson's PermaTran III (may be a higher roman numeral these days, as I haven't bought "MF brand" oil in a long time) - and Various other names that most Universal Tractor Transmission & Hydraulic fluids go by. DO NOT use straight hydraulic fluid or straight transmission fluids. You will not get as good of performance, and you will not have the right additives in your oil for the application. Your rear axle final drives may be separate from your transmission. I believe they are. For them, a good 80W-90 or SAE 90W oil would suffice. Kudos! ~AJ
Did Manchester United be relegated with Sir Alex Ferguson?
No, Manchester United did not get relegated under Sir Alex Ferguson. The lowest league position achieved under Ferguson was 13th (out of 20) in the 1989/90 season.
Is there a carburetor filter on a 90 dodge neon?
No, because there is no such thing as a 90 Dodge Neon
How do you Bend 2'' pipe 90 deg?
With a pipe bender of course hydraulic would be the best choice
3.1 Chevy what type lifters on 90 beretta roller or flat HYDROLIC?
The 1990 will take flat hydraulic.
Where do you add hydraulic oil on bobcat 963?
on the front of the machine, there is a plug (alan wrench style.) if it is leaking from the axle seal it is not hydraulic, it should be 80/90. add to the chain case through the plug on front.
