answersLogoWhite

0


Best Answer

no have , per wiring diagram.There is no IAC motor for this engine and I suspect you have an error code

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is iac valve on 2004 ford f150 4.6 v8?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is IAC valve on 2001 Ford F150 5.4l?

IAC sits on the top of the motor.


Where is the IAC Valve located on 2004 dodge 5.7 hemi?

Where is the iac valve located on 2004 dodge 5.7hemi


Why does my 1986 ford f150 idle rough and sometimes stalls?

A bad IAC (Idle air control valve) or a vacuum leak or both.


Where is IAC valve on 1989 Ford F150 5.0 V8?

On top of the intake in front of the throttle control. it has a two wire plug going into it.


What is p1506 code on a 1998 Ford Expedition?

iac valve...idle air control valve


Where is the iac valve on a 1994 ford e 150?

PvHNPI csvhqbbekdtw


Where is IAC valve location on 1997 Ford Taurus?

Its on the back of the throttle body.


Why does your 1999 ford escort run rough at low iddle?

Because the IAC valve is faulty.


Where can you find the idle air control valve on a Ford Ranger?

The Idle Air Control (IAC) valve is mounted on the throttle body


How do you change the idle air control valve on a 1998 Ford F150 super cab?

REMOVAL & INSTALLATIONFig. 2 Detach the connector for the IAT valve and ...Fig. 3 ... remove the retaining bolts for the IAC and ...Fig. 4 ... lift the IAC valve off of the engineFig. 5 Remove and replace the gasket with a new oneFig. 6 Thoroughly clean the mating surfaces of the IAC and the engine# Disconnect the negative battery cable. # Remove the air cleaner inlet tube and the throttle cover, if necessary. # Disconnnect the wiring harness from the IAC valve. # Remove the two retaining bolts. # Remove the IAC valve and discard the old gasket. To install: # Clean the gasket mating surfaces thoroughly. # Using a new gasket, position the IAC valve on the throttle body. # Install and tighten the retaining bolts to 71-106 inch lbs. (8-12 Nm). # Connect the wiring harness to the IAC valve. # If removed, install the air cleaner tube and throttle cover. # Connect the negative battery cable.


Why does a ford zx2 stop running when the air is turned on?

The IAC (Idle Air Control) valve is faulty.


Where is the iac solenoid and how do you remove it on a 2001 ford f150?

IDLE AIR CONTROL VALVE (IAC) Definition: An electrically-operated valve which allows air to bypass the throttle plate in a fuel injected engine to regulate engine idle speed. IDLE AIR CONTROL VALVE (IAC) The (IAC) is located under the Triton Plastic cover in the middle of the engine compartment. Very easy to replace. There are two bolts and one plug.It should only take you around 10 or 15 minutes to change. Buy it new; it doesn't even pay to clean it. It works half the times. But it will go bad eventually…