Thermistat is on top of the engine in front of the intake. Usually where the top radiator hose is. Just take the top radiator hose off and then unbolt the housing and thermistat should be right there.
The ECM on a 1992 S10 Blazer is located below the glove box.
In the fuel tank.
under the master cylinder.
Front center of radiator support.
Behind the passenger side kick panel or behind the glove compartment.
Usually in housing at engine end of upper radiator hose
No. A Chevy Blazer does not have a reset switch.
where is the thermostat located in a 1992 cutless supreme automobile
Not unless the 1992 is 4x4.
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
Remove the water supply hose from your 1992 Chevy thermostat housing. Remove the thermostat housing retaining bolts. The thermostat can be lifted out. Reverse the process to install the new thermostat.
There is none. You have a fuel pump relay in your electrical center.