0
Where is low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6?
Wiki User
∙ 9y ago
The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Where is the tps located in a 1993 Oldsmobile cutlass ciera?
Its located on the bottom of the throttle body right next to the fuel pressure valve.
Where is egr valve on 1993 cutlass ciera?
The EGR is the acronym for exhaust gas recirculation valve. The 1993 Cutlass Ciera does not come equipped with an EGR valve.
How do you locate and replace the PCV valve on a 1989 Oldsmobile Cutlass Ciera?
The PCV valve is located in the rocker cover (valve cover) Once you locate it pull up on the hose that is connected to it. Remove the PCV valve and put new one in. Reinstall in rocker cover.
Where is the oil pressure switch located on a 1995 Oldsmobile Ciera?
Under hood, center, front engine area, below valve cover, mounted in engine block.
Where is modulator valve on a 1994 cutlass ciera?
underneath the green and red stripy cats hat by doctor seus
Where is the modulator valve located on a 1992 Oldsmobile cutlass located?
In the transmission in front of the modulator
Reasons for poor idle quality of a 1995 olds cutlass ciera?
it's the idle control valve, $60 part, or the computer.
Which line is the high pressure line on the air conditioner cooling system of an 1992 Oldsmobile Cutlass?
Most high pressure lines have a red cap on them, and they are usually smaller in diameter. It runs from the condenser to the TX valve/Evaporator.
Where is the purge valve located on a 1996 Oldsmobile Cutlass Supreme?
wher is the pcv located on a 1996 olds cutlass supreme 3.4 l engine
Where is the pcv valve located on a 1991 Oldsmobile cutlass supreme?
its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.
What are the torque specs for the intake manifold fuel injection and valve adjustment on a 1996 Oldsmobile Cutlass Ciera 3.1L engine?
the torque specs for the intake manifold are 115 inch pounds inch pounds to newton meter = mutiply .113 by the number of inch pounds aprox. 9.5 foot pounds
Why won't my rear disk brakes on a 1994 Oldsmobile Cutlass Supreme bleed?
Equalizer valve not allowing fluid flow to rear?
