Where is egr valve on 1993 cutlass ciera?
The EGR is the acronym for exhaust gas recirculation valve. The 1993 Cutlass Ciera does not come equipped with an EGR valve.
You owned a 95 cutlass ciera and you need to replace the EGR valve your question is what type of screw driver would you need to take the screws out of the old egr valve in order to replace it?
They are not screws they are bolts either 1omm or 13mm
yes it is located on the top of the manifold, back side of the motor next to the throttle assembly shield. It is electronically controlled
As I recall, that engine does not have an EGR valve.
its the hose coming off of the valve cover that's the egr valve
if this is a v6, unless your car has California emissions, there is no EGR valve.
1990 -1993 injected Festivas do not have a EGR valve
The 1993 Ford escort did not come with an EGR valve. It is one of a few year models that do not have one.
As far as I can tell, there is no EGR valve on 1993 Ford Aerostar 3.0L engines. I have searched and found none and the vacuum hose routing decal in the engine compartment does not show an EGR valve.
The EGR position sensor is located on top of the EGR valve. Has an electrical connector attached.
It is a 50 EGR Valve. You can use it for '93-'97 Dodge Dakota, Ram 1500, 2500, or Jeep.
The P1406 code on a 1996 Oldsmobile Cutlass Ciera 3.1 is the code for the EGR pintle position circuit. I know this because it was my question initially and we bought a code reader to check the problem. It is a factory specific code, so the answer is quite specific. Good luck !
The Red line is the Vacumme line the comes from the drivers side of the intake to the EGR selonoid (at the top) the Green line goes from the EGR selonoid directly to the EGR valve (at the bottom of the Selonoid).
The EGR valve is located at the front of the h22a4 engine. The EGR valve is right beside of the front of the EGR valve.
If it is an electronic EGR valve it is on the top of the engine on the rear left or drivers side it has three solenoids and a wire harness at the top IF YOU HAVE THE V6 (3.3) ENGINE IT DOES NOT HAVE AN EGR VALVE. IF YOU HAVE THE 2.2 4 CYL YOU HAVE A VACUUM TYPE EGR LOCATED ON THE END OF THE HEAD ABOVE THE TRANS.
Its a 3300 3.3 3.1?? drivers side rear coner of engine (top of). Its an electronic EGR with 3 valves on it. REmove it and check the passageway below it as it carbons up and will give you an EGR failure code/symptom
On the 4.0 L OHV engine, the EGR valve is located on the driver's side of the engine. how do i repair it
Why does your 1993 Chevy S10 Blazer begin to stall when you come to a stop and Once you turned it off it won't start back up?
Check your EGR valve Check EGR valve
Start the engine, and spray a little carb cleaner around and on the EGR valve. If the engine changes sound are idles up are down then the valve is bad.
Where is the EGR valve located on a 1993 Plymouth Voyager 2.5 - It's not where the diagrams say it should be- to the left of the throttle body.?
Some vehicles dont have EGR Valve... I have a 90 Caravan, same engine as yours, basically the same thing as what you have and it has the EGR valve, then again, same engine in my 92 Dodge Spirit and it has no EGR Valve... the EGR is just mainly an emissions thing to help keep down on air polution. If yours did have the EGR Valve, they are really easy to spot, its on the… Read More
It means that either your EGR solenoid or EGR valve is bad. The EGR valve sometimes sticks open due to carbon build-up. This can be fixed by removing it and cleaning the valve piston with carburetor cleaner and a metal brush. The EGR valve could also have a bad diaphragm. You can check this by connecting a vacuum hand pump to the EGR valve and checking to see if the valve holds vacuum. If it… Read More
check egr system,make sure vacuum reaches egr valve when is supposed to
1) Unplug the electrical connector for the EGR valve lift sensor. 2) Remove the two nuts that secure the EGR valve and detach the valve. 3) Clean the mating surfaces of the EGR valve and adapter. 4) Install the EGR valve using a new gasket. Tighten the nuts securely. 5) Plug in the electrical connector. These instructions come from the Haynes repair manual for Honda Accord 1990-1993 which also has good illustrations.
Should be at the front of the motor under the air breather on your intake.
It is an electrically operated valve that when energized let's the vacuum through to the EGR valve to open it. Many also contain an electical switch that is closed when the vacuum is applied to the EGR valve to send a confirmation signal back to the ECM (engine control module).
It is on the left side of the TBI Throttle body, and it screews into the side of it. with a electric connector plug on it. ( Idle speed control) The EGR valve is on the lrft side of the intake manifold, close to the valve cover.
Yes, the EGR valve, or port EGR
The EGR valve on mine is behing the intake manifold. Comes off the back exhaust manifold. Right behind the inake inlet.
Starter solenoid: on the starter. EGR: on the egr valve transmission: on the valve body in the trans. Starter solenoid: on the starter. EGR: on the egr valve transmission: on the valve body in the trans.
The B2600i does not have an EGR valve, because the truck is fuel injected the ECU monitors driving conditions and retards ignition timing to lower NOx emissions. Kyrasis6 Mazdatruckin.com
It probably doesn't have one. If you don't see it stuck on the driver's side of the throttle body, that one came EGR valve-less.
I have a 93 4.0 and it has no EGR valve. My neighbor who is a ford mech. says some don't have EGR's and some have only one O2 sensor.
The PCM controls the EGR valve, so the EGR position sensor tells the PCM what position the EGR valve is in, so it can control the EGR valve and ake other necessary adjustments.
The 2002 Mercury Mountaineer EGR valve can be found in the engine compartment, on the firewall. The EGR valve will be labeled as such.
No, you can not swap between EGR and non EGR engines.
It doesn't have an Egr valve. It doesn't have an Egr valve.
does a Hyundai tiburon have a egr valve
There is no EGR valve on an Aspire.
There is NOT an EGR valve on this engine.
It doesn't have an egr valve.
On the egr valve.
The E.G.R. Valve is located below the intake manifold, close the throttle body between the engine and the firewall. I owned a 1993 probe with an automatic transmission. It did not have an EGR valve. I gutted the car and replaced the complete wiring, suspension and running gear with manual transmission out of a 1994 SE, the 94 had the EGR just as stated above. It also changed it to an OBD2 diagnostics port.
It does not have EGR. It does not have EGR.
Remove the EGR valve vacuum lines. Remove the EGR valve retaining screws. Wash the EGR valve in hot water. Allow the valve to thoroughly dry before installing it.
The EGR valve is located on the top of the 1985 Mustang engine. The EGR valve is mounted right behind the carburetor.
Remove the wiring harness from your 2000 Dodge Stratus EGR valve. Remove the EGR valve retaining screws. Reverse the process to install the new EGR valve.
93 Roadmaster.... that's a 5.7L engine, right? It should be attached to the intake with 2 bolts. Look for the thing that looks like a Chevy Smallblock EGR valve. Also, if you're replacing the valve because you have an EGR code make sure you don't have a clogged passage in the intake acting like a bad valve.
It is under the air cleaner system, on the front of the engine.
If equipped, it is behind and to the passenger side of the throttle body.
Everything since the 60s. Yes. there are a few without.
There is no EGR valve on this generation of Corolla. This engine is equipped with VVT-i (variable valve timing with intelligence), that allows it to perform the function of EGR without the former EGR hardware.