Find the box that contains your AIR FILTER. There is an aluminum- looking housing bolted or screwed to the air box. It is the housing for the sensor. There should be an electrical connector to it also. Keeping the filaments of the sensor clean help alleviate driveability problems with the Ranger (and ALL vehicles). If you clean it, be easy and dont stick anything into the housing. Just spray with BRAKE CLEANER and let air-dry before reinstall.
i read were your not to use brake cleaner
It doesn't have one .It has a mass air flow sensor in the air intake tube to the air cleaner .
On a 2002 Ford Ranger : The Mass Air Flow Sensor is between the engine air filter and the engine air intake tube
its on the air filter housing
its right on the airfilter box on the top of it
It doesn't have a knock sensor on the 4.0 L OHV in a 1993 Ranger ( my 1995 Ford Explorer 4.0 L OHV engine doesn't have a knock sensor either )
vacuum leak
Where is the ford ranger 2004 revcounter sensor conected
Where is the water temperature sender 1995 ford ranger 2.3?In: Ford [ranger]
1995 ford ranger 4wd cranks over but no spark, replaced crank sensor Check battery power to coil connector, if that is good coil can be tested w/multimeter.
On a 1995 Ford Ranger : The ODOMETER is near the center of your speedometer
On a 1995 Ford Ranger # 17 fuse is for the cigarette lighter.
The Mass Airflow sensor (MAF) is located between the air filter housing and the air intake duct. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.