Top Answer
User Avatar
Wiki User
2006-11-12 16:08:49
2006-11-12 16:08:49

What do u mean? if u meanthe engine number then check under the intake manifold at the driver side just below the throttle body deep down.


Related Questions

Fuse block in engine compartment right side.

On the V-6 engine, it is located on the drivers side block just above the oil filter. On the 4 cylinder is also on the drivers side block behind the alternator.

The thermostat on a 1991 Toyota 4Runner is located on the engine block. It can be found by following the large hose coming from the radiator.

The engine oil sits in an oil pan that is bolted to the bottom of the engine block.

The Toyota Camry block heater is located on the front of the engine block. You can follow the block heater cord to the block heater.

Im having problems removing the A100 fuse from a 99 Toyota 4runner from behind the battery

Its located right in front of the engine block

The block heater is located near the engine on most cars. This is true also for the 2003 Toyota Rav 4.

FRAM 3614 and it's located on the front left part of the engine block on top

They are installed in holes in the engine block where the frost plugs are normally located

Is on the engine block on the upper water hose.

If its for 1995 4 runner and older, it's on relay block #3 located behind the globe compartment..(right side, on the pillar)....

Fuel filter is located under the intake manifold and bolted on the engine block.

you have to remove the intake and it is located inside the engine block,you can see it once you remove the intake........

It is on the right-hand (passenger side) of the engine block about half way down.

On my 92 Toyota Pickup V6 4X4, it is located in a different section than on the 4cyl. If you are looking straight at the engine, look to your right and down into the engine. Look for the LOWER radiator hose and follow it into the engine block. Romove the housing and this is where the thermostat on my truck was located

The thermostat is located under the alternator on the engine block. Just follow the lower radiator hose to the engine block and is held in place by plastic housing with two 10mm nuts.

beside the block on right under intake in your right

Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.

I own a 1986 Toyota pick up with a 4 cyl. 22R engine, and the fuel pump is located at the top left hand corner of the engine block ( looking at the engine from the front of the truck ).

It is located on the engine block on the opposite side of the exhaust manifold to the right of the starter unit.

follow the bottom rad hose to the block. remove the bolts and its between the block and the neck

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.