Want this question answered?
The air bad "control module" is located under the front dash, behind the stereo. You will likely need to reset or replace the control module if your SRS (Supplemental Restraint System) light stays on. The air bad "control module" is located under the front dash, behind the stereo. You will likely need to reset or replace the control module if your SRS (Supplemental Restraint System) light stays on. The air bad "control module" is located under the front dash, behind the stereo. You will likely need to reset or replace the control module if your SRS (Supplemental Restraint System) light stays on.
I'm not a mechanic / technician but I believe that the 4x4 Control Trac system on a 1995 Ford Explorer does not have a separate control module I believe the 4x4 system is controlled by the GEM ( Generic Electronic Module ) and that it is located in the center stack of the dash near the radio
Connector "J", Pin# 04 is the wire for the speed sensor on the BCM(Brain Control Module). I only know this from downloading the schematic from hyundai's web site. I needed this information when I installed my GPS system. Hope this helps you.
The "brain" of the ignition system, the Ignition control module controls the ignition timing and strength, as directed by the main computer. It can be located in a variety of places, but it can normally be found underneath the hood.
The "brain" of the ignition system, the Ignition control module controls the ignition timing and strength, as directed by the main computer. It can be located in a variety of places, but it can normally be found underneath the hood.
Control module
Control module
yes
Where is the sensor of the transmission control located Answering the first question since the second makes no sense. The car's Electronic Control Module is located under the carpeting on the front seat passenger's floor.
Taking a guess, Your 1988 5th Ave has a 318ci motor with Lean-Burn Engine control. Chrysler put the control module in the rectangle box attached to the side of the air cleaner. All of the engine control module is inside that box to include the transistorized ignition system. Your distributor will have two pickup coils in it and not have a vacumn advance located on the side of it which will be another way of telling if you have the Lean-Burn system.
The Hydraulic Control Unit for the 1995 Ford Ranger 4 wheel anti-lock brake system 4WABS is located in the engine compartment on the left front inner fender panel. It consists of: the brake pressure control valve block, pump motor and hydraulic control unit reservoir. The "brains" of the 4WABS in the Ranger is the Brake Control Module, or Electronic Control Unit (ECU). The ECU/Brake Control Module is mounted in front of the right front corner of the battery on the radiator support.
The body computer and engine computer both control theft alarm functions. It is not an individual module.