Want this question answered?
Usually T1's are terminated on an RJ48 jack. If the T1 line is provided by a telecom company, a T1 Network Interface Unit (NIU) is often installed with an RJ48 jack. A T1 NIU may also be referred to as a 'smart jack,' a device which allows remote, and on-site, loop up and testing capability, as well as indicator lights for basic fault isolation. An RJ48 jack accepts an 8-position, 8-contact (8P8C) modular connector. It's important to note that RJ48 jacks and connectors are often confused with RJ45 (Ethernet) jacks and connectors, because they may look identical, but RJ48 uses a different wiring standard and a different pinout - uses pins 1, 2, 4 & 5. However, some RJ48 jacks and connectors have a keyed notch on one side.
A small triangle on the connector is the indicator for the positive lead. This marks one of the outside wires as pin 1. Line up pin 1 on the connector with the pin 1 found on the motherboard.the wire nearest the triangle is pin 1
The 2 pin conecter is for computer communication
STAGE PIN 1, TWISTLOCK 2, EDISON 3
Pin 1 = ground/shield, Pin 2 = hot/plus, Pin 3 = cold/minus
8-pin power supply connector, 150watts
14 pin gray connector directly above brake pedal under dash
The red stripe on the ribbon cable indicates pin #1. Usually, pin #1 on the device is the one closest to the power connector.
RS-232RS-422ParallelGPIBUSBetc.
1) connect the ip phone to the ethernet LAN using an rj45 connector 2) establish an internet connection then use an analog telephone adapter.
Follow the upper radiator hose to the thermostat housing. The coolant temperature sensor for the ECU (2-pin connector) is on the driver's side. The temperature sender for the guage (1-pin connector. is on the opposite side.
1. Physical layer