Pin 1 = ground/shield, Pin 2 = hot/plus, Pin 3 = cold/minus
a usb cable is a cable that allows the computer to communicate with the object u are connecting it to. For example there is a computer powered fan which is connected to a computer using an usb cable
Make sure the monitor eletrical cable is plugged in. Make sure the monitor is turned on. Make sure the monitor cable is plugged into the video port at the back of the PC and the connector on the rear of the monitor.
why we are using thick size of feeder cable in tele network?
1) Twisted pair cable is less expensive2) Twisted pair cable is required for modern transmission standards****************It is a thin, flexible cable that is easy to string between walls.Because UTP is small, it does not quickly fill up wiring ducts.UTP costs less per foot than any other type of LAN cable
There were 3 methods of using ethernet. At this point only the hub with cat5 wiring is being used. The two older methods were a. use of a very thick coax cable with each station employing a tranceiver and a tap into the coax. and b. thinner coax cables with BNC connectors daisy chained from station to station. Called 10base2. So this is an obselete 10M ethernet network.
To properly install and connect BX wiring in your home, follow these steps: Turn off the power to the area where you will be working. Remove the old wiring if necessary. Measure and cut the BX cable to the appropriate length. Strip the outer sheathing from the cable. Connect the cable to the electrical box using a cable connector. Strip the insulation from the individual wires. Connect the wires to the appropriate terminals or screws in the electrical box. Secure the cable in place using cable staples. Turn the power back on and test the connection to ensure it is working properly. Remember to always follow local electrical codes and regulations when working with wiring in your home.
Same installation as non armored cable.
To wire a Cat 5 cable for network connectivity, follow these steps: Strip the outer insulation of the cable to expose the inner wires. Untwist the pairs of wires and arrange them according to the T568A or T568B wiring standard. Trim the wires to the appropriate length and insert them into the RJ45 connector. Crimp the connector onto the wires using a crimping tool. Test the cable to ensure it is properly wired and functioning.
Sometimes this will happen if you are using a coaxial cable on the antenna and there is a broken connector or even a cut in the cable somewhere.
To terminate an RJ45 connector, first, strip about 1 inch of the outer insulation from the end of the Ethernet cable using a wire stripper. Untwist the pairs of wires and arrange them according to the T568A or T568B wiring standard, ensuring correct color order. Trim the wires to about half an inch, insert them into the RJ45 connector, and use a crimping tool to secure the connector onto the cable, ensuring each wire makes contact with the metal pins. Finally, test the connection with a cable tester to ensure proper termination.
YOu don't
download and install itunes, then plug your ipod to the computer using the dock connector cable
The advantages of using a 3-wire electrical cable for residential wiring include improved safety, better grounding capabilities, and the ability to support both standard and specialized electrical circuits.
I am assuming you have bulk cable available, RJ-45 connectors and a crimping tool. Wire one end of the cable using the T568-A wiring standard, and the other using T568-B. That's your crossover cable.
A toslink cable has a round connector that provides digital audio data using small pulses of light instead of electricity. It is manufactured by Toshiba.
Most HDTVs have an S-Video connector -- simply attach the cable.
UTP or STP Cat 5 cable uses an RJ-45 connector.