0
There were 3 methods of using ethernet. At this point only the hub with cat5 wiring is being used. The two older methods were a. use of a very thick coax cable with each station employing a tranceiver and a tap into the coax. and b. thinner coax cables with BNC connectors daisy chained from station to station. Called 10base2. So this is an obselete 10M ethernet network.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What type of connector does a 100BASE-T network require?
RJ-45 or 8P8C modular connectors
Round connectors used by coaxial cable?
BNC
Which connectors are supported by 3c900b-combo?
Bnc,rj-45
Which cable connector is used in a 1000BaseT network?
10base-T uses for twister pair cable which speed 10mbps.
What is the name of the connector used on a network cable?
UTP most commonly used network cableCat 5 and Cat 6 network cables (also called 10BaseT) use an RJ-45 connector. Older thinwire ethernet (10Base2) uses BNC coaxial connect. Original thickwire ethernet used a special thicker cable with a proprietary AUI connector. The old IBM Token Ring system also used its own special cabling and connectors.
What type of connector does a 100BASE-T network require?
RJ-45 or 8P8C modular connectors
What type of connectors have a round shape and use a bayonet-type locking attachment similar to a BNC connector?
ST connectors
Which of the following connectors is commonly used on a coaxial cable?
The most common connectors for coaxial cables are F-type and BNC.
What connector is used to connect 10Base5 to a PC's network card?
I think it uses BNC connectors.
Round connectors used by coaxial cable?
BNC
Which connectors are supported by 3c900b-combo?
Bnc,rj-45
How do you affix bnc connectors to coaxial cable?
Hi, True BNC connectors have four parts. The main body, a metal washer, a specially shaped rubber washer and a screw in ferrule to hold it all together. They also require some soldering to do it properly. And since you're asking, installing a true BNC connector would require several pages of typing to explain how. There are two alternatives: Find a broadcast engineer or video technician who'll show you the process, or just get some screw on type connectors, which are easy to figure out and install. They'll also work quite dependably, too. Hope this helps, Cubby
What is the most common type connector used with coaxial cable on a ThinNet Ethernet network?
BNC
Which connector would be used in a 10BASE2 Bus topology?
BNC connectors, Ts, barrel, 4ways, and the all important terminator.
What is the most common type connector used with coaxial cable on at ThinNet Ethernet network?
BNC connecter
What is the most common type connector used with coaxial cable on a ThinNet internet network?
BNC Connector
What are the proper requirements for a 10Base2 network?
The requirements for a 10Base2 network: RG58u Coaxial cable T-connectors BNC's Terminators Ground, usually a ground chain Internetworking with Cisco and Microsoft Technologies pg. 226 and 227
