0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is speed control sensor on a 1995 Plymouth Voyager?
If you are refering to the vehicle speed sensor (VSS) it is on tranny by where the axles are
What does a speed sensor do in a 95 Plymouth Voyager?
the speed sensor senses the speed and tells your transmission when to shift , it also controls your speedometer.
Where is the input speed sensor on a 1990 Plymouth Grand Voyager?
The input speed sensor is the two wire sensor on the front of the transmission case closest to the engine.
How do you repair a code P0500 on a Plymouth Voyager?
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
Where is the trans sensor located on a 96 Plymouth voyager 3.0?
right on the trans they are plug ins one is a speed sensor
What does an output speed sensor do on a 1996 Plymouth Voyager?
It measures the speed of the output gear of the transmission. It is used for shift timing.
Where is the MAF sensor on a 1993 Plymouth Voyager and is it difficult to replace?
A Plymouth Voyager does not have a maf sensor.
How do you adjust idle on 98 3.0 Plymouth Voyager?
It is not adjustable. If the idle speed is not correct, then you have a sensor/actuator/computer issue.
Where is speed sensor located for 90 Honda Prelude SI?
I am in the process of replacing the speed sensor in my 90 prelude. It is located on the transmission. with a small cable with a plug on the end of it. Looking at it from the passenger side . you can see a picture of it on eBay.. just type in 1990 Honda speed sensor.. there are several...
Where is the low coolant sensor relay for a Plymouth voyager?
No such part on a Voyager.
Where is the speed sensor at on a 1991 Chevrolet Lumina Van?
The speed sensor on a 90 lumina 3.1 should be on the drivers side top of the tranny, below the steering rod. Sould be a screw in sensor with wires attached.
How do you replace a speed sensor on a 2002 Chrysler Voyager?
Open the hood,remove air filter box and look to the right near the end of the trans axle is where the sensor is,remove the connector with two wires in it.then remove the sensor.
