Want this question answered?
The 2005 Peterbilt M 11 Cummins diesel engine map sensor is located next to the fuel pump. The map sensor should be labeled as such.
a 1993 doesn't have a cam sensor. the crankshaft position sensor is located on the front of the engine directly above the crankshaft pulley
1997 Dodge diesels come with the 12 valve cummins engine. It is fully mechanical and does not have a camshaft position sensor. "Dodge cummins diesel forum" is a good resource for dodge cummins owners.
Engine Oil Rifle Pressure Sensor 1 is located on the left side of the engine block, about 1/3 way to the back.
Cummins (OEM) 12 valve (single wire) oil pressure sensor is located below the injection pump and could be in front of or behind injection pump support bracket. The location was determined by the factory installing the engine. Cummins (OEM) 24 valve (three wire) oil pressure sensor is located below the ECM.
The speedometer signal comes from the transmission computer via the output speed sensor on the front of the transmission case. The tachometer signal comes from the engine computer via the crankshaft position sensor on the rear of the bell housing.
The tachometer cable may be faulty. The tachometer sensor, on the side of the engine might not be functioning properly.
I think the sensor are on the gearbox , and send it to the transmision ecu
oil pressure sensor location n14
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.
Engine Position Sensor.