the sensor is located on the left exhaust pipe just before the pipe bends under the car. It can be seen under the hood from drivers side near fire wall. Do not attempt to use a meter on the sensor. Probably should be changed about every 40 thou. It is easier to remove it if you run car and warm pipe. Disconnect plastic wire connector first. Be careful not to strip female threads on pipe. Wear gloves if you are sensative to heat. Before installing make sure new sensor has anti seize compound on threads. DO NOT install without this. (cw)
Corvette didnt have a Crankshaft Position Sensor until 96.
Behind the glove box
No. There are three different tops for the C4 Corvettes, 84 to early 86, late 86 to 88, and 89 to 96.
What type of sensor? The tire pressure sensor is located in the wheel.
The 1990 Chevrolet Corvette IAT sensor does have two wires. The sensor has a ground wire and a positive wire.
Corvette Summer was created on 1978-06-02.
Yes.
I
Could be your starter.
Japanese corvette Hiei was created on 1878-02-25.
Little Red Corvette was created on 1983-02-09.
Japanese corvette Musashi was created on 1887-02-09.