You will find it under the steering wheel covers and plate (3 of Them) First remove the fuse cover panel located on the Far Left end of the dash board drivers side, which you pull upwards. Next unscrew the Top plastic cover under it held in with Phillip Hex Head screws, under that you will find a Large 5x 10 approx. (Metal Panel held in with 10mm Hex Head screws (unscrew it). To the rear upper left You will see Original Relays, the one your looking for is located to the right of one that has an Orange end connector ( if not sure turn signal on and you will feel it clicking, Disconnect the Orange connector by pressing on the bottom tab, pull it out and put it aside, Next you will need to disconnect the combo flasher connector which is a pain because the heat that distorts the plastic and makes it almost impossible. You can use a 10 inch screwdriver inserted in between the bottom edge of the relay and the plastic lock in tab , turn it clockwise to snap the Tab (Replacement combo relay does not have this tab, so to secure it after installing, use tie straps. Install new one ( PepBoys sells one for 32.00 with tax made by Tridon Novita LM470 Lighting Control Module ) and test.
This is used for aftermarket replacement and used for replacement when you use L.E.D kits which needs a Heavy Duty Resistor Relay or else you will keep investing in O.E.M parts at a very high cost.
Most people believe it is the turn signal switch handle because they can hold it partially up and works , but its not. That would cost 92-130.00 plus an extra 4 hrs and rarely fails unless you intentionally try to break it.
Let me tell you, first you will do all this upside down leaning your head on the floorboard, so if you have a bad back? Have a buddy do it while you read directions, buy him some beer and save yourself a Ton of Cash! Goodluck and dont lose all the Screws! If you have Questions feel free to text me at Pooltipster@gmail.com
The turn signal switch is mounted inside the steering column and you control it with the turn signal lever. The turn signal Flasher Relay is located: Behind center of instrument panel .....by the way, the gas pedal is on the right, and the brake is on the left
The relay is located under the driver side dash it will be a black box located right next to the yellow box you cant miss it as they are right next to each other and they are the only ones there......
A 2000 Chrysler 300m does not have a heater valve. The cabin temperature is controlled by airflow doors.
where is the engine control modulator located in a 2000 Chrysler 300m
Chrysler does not use inertia or reset switches.
Yes.
Just behind the engine, in the passenger side of the bell housing.
what bulb? if you need to change exterior front or rear or indicator? let me know.
the 300M if it has the hemi engine.
Yes
no
Belt