0
Under the hood on the passenger side you will see a small box on the firewall with a plug-in...its held in with two screws..remove the plug-in, the screws and pull out the resistor. replacement is the reverse.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is location of blower motor resistor on 03 infiniti i35?
location blower motor resistor 92 J30
Where is the blower resistor on a 92 Honda accord lx?
The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it. The Resistor is located on the outside of the blower motor. Have to remove the blower from under the glovebox to get to it.
Will a fuel pump from a 99 Dodge Durango fit on a 92 Dodge Dakota?
No
92 stealth blower motor spins only on high no other setting what could possibly cause this?
could be the resistor on blower motor is bad
Will a transmission out of a 5.9 98 dodge ram bolt up to a 92 3.6 dodge Dakota?
no
Is a 99 Dodge Durango fuel pump and a 92 Dodge Dakota fuel pump interchangeable?
No
Where is the transmission vacuum modulator on 92 dodge Dakota?
Dodge transmissions do not use vacuum modulators.
How is the dash removed from a '92 Sentra sufficiently to access the blower switch?
If you are trying to get to the blower switch because there is only one speed on the switch which is high, the problem is not the switch. It's the resistor in the blower motor and is ususally accessable in the passenger side floor. At least on my 92 that's where it was. You take out the two bolts, unplug the resistor plug in the new one and the process is done.
How much oil does a 92 dodge Dakota with 5.2 take?
5 quarts
Non stop blower motor 92 maxima have searched the postings and found several similar reports but no solution you have a 92 maxima with auto climate control the blower fan runs at high speed and high?
Replace your blower motor resistor Resistor located under dash on passenger side in screwed into blower housing. May be able to be repaired. Requires soldering a small piece of "unmelted solder" across where the old fusible link was. look carefully at resistor. Or else just replace. Buy new. Junkyard resistor likely to be as bad as yours.
The engine code 11 for a 92 Dodge Dakota 3.9L?
No crank reference signal.
Reset maintenance required light 92 Dodge Dakota?
aperantly take the light out
