The ABS sensor is located in the front brake set up. It is accessible by removing the tire and the caliper bolt, caliper, and rotor. It will be a black plug connected to a wire sitting on the top.
where is the tcm in a windstar 2000 located
Left side of car, first sensor towards the front.
on top of the transmission
electronic module
There is no MAP sensor on a 1999 Windstar.
The crank position sensor on a 2001 Ford Windstar van is located on the bottom of the engine. It constantly monitors the engine's crankshaft and reports information to the computer.
The speed control device or speed sensor on a 1995 Ford Windstar is located on the transmission. It is a plug in just behind the bell housing.
The 2000 Ford Windstar ABS relay switch is located on the firewall in the engine compartment. The relay switch will be on the passenger side of the engine compartment.
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
It should be located between your air filter housing and the engine.
where is air flow relay on 2000 ford windstar
it is on the trans,right side you will have to remove cat.converters to access.