Want this question answered?
The block heater cord on a 2010 Ford Escape is located along the side of the engine near the oil dipstick. It is held in place with mounting bolts and warms the engine quicker in cold weather.
It is tied up and located behind one of the headlights. Mine is located behind the driver's side headlight.
A block heater for that vehicle would be an option. If it came equipped with a block heater the cord would be found close to the battery.
in the sub-grille with the tow hooks
Where and how many oxygen sensors are there on a 2010 fusion with a 3.0 v6 engine. Also when facing the front of the car which side of the engine is left and which is right
According to the 2010 Ford Fusion Owner Guide : The fuel pump shut off switch ( inertia switch ) is located in the front passenger footwell , in the right corner
first, an engine heater has to have been installed on the vehicle. if the car did have an engine heater installed in it, most newer vehicles would have had a soft plug heater put in. soft plugs are located on the side of the engine block. they knock that plug out and install a heater in it. look for any ac wire( it will look like a three prong plug on any of your household appliances) in the engine compartment.
Right below the passenger side headlight where your tow hooks are.
The 2010 Ford Fusion has 16 valves.
The 2010 Ford Fusion is a gas-powered vehicle.
The 2010 Ford Fusion has a 6-speed manual.
The 2010 Ford Fusion has an inline 4 engine.