= EGR Valve = 4.2L, 4.6L, 5.4L and 6.8L Engines 1. Disconnect the negative battery cable. 2. Remove the vacuum hose from the EGR valve. 3. On the 4.6L engine, remove the nut and brake booster bracket. 4. On the 5.4L engine, remove the DPFE sensor retaining nuts and place the sensor to the side to allow access to the EGR tube. 5. Disconnect the EGR valve-to-exhaust manifold tube from the EGR valve. 6. Remove the EGR valve mounting bolts, then separate the valve from the intake manifold. 7. Remove and discard the old EGR valve gasket, and clean the gasket mating surfaces on the valve and the intake manifold. To Install: 8. Install the EGR valve, along with a new gasket, on the manifold, then install and tighten the mounting bolts. 9. Connect the EGR valve-to-exhaust manifold tube to the valve, then tighten the tube nut to 25-35 lbs. (34-47 Nm). 10. Connect the vacuum hose to the EGR valve. 11. On the 5.7L engine, install the DPFE sensor. 12. On the 4.6L engine install the brake booster bracket and the retaining nut. 13. Connect the negative battery cable.
where is the vin located on a ford f350 frame 1989
location and replacement of pcv valve and egr valve on 2005 Ford Taurus se
No, the 2003 Ford F350 rims will not fit on a 1999 Ford F350.
Yes, the rims off a 2002 Ford F350 will indeed fir on a 1999 Ford F350.
Contact the Ford company or join the local Ford users group
Did you ever find the location of the pcv valve?
EGR valve is on the Back side of the intake manifold, close to the throttle body, right in the middle of the engine compartment.
It bolts to the intake manifold near the throttle body.
Located behind the intake manifold on the drivers side. Very hard spot to get to.
The idle air control valve on 2005 ford escape in located under the hood on top of the throttle body. Use the manual to find help.
no changed in 2003
egr valve location on a 1997 ford ranger 23l