0
Where is the Engine Coolant Temperature Sensor on a 1999 Taurus?
Wiki User
∙ 8y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
1998 Ford Taurus engine coolant temperature sensor- low input location?
where is the engine coolant temperature sensor- low input locationon a 1998 ford taurus
Where is coolant temperature sensor located on 1989 Taurus?
The coolant temperature sensor on an 89 Taurus with a 3.8L V-6 is located directly above the thermostat, where the upper radiator hose connects to the engine. the sensor is positioned vertically and has 2 wires coming off of it.
Where is the coolant temperature sensor located on a 2000 Ford Taurus?
Next to the thermostat housing.
Where is the coolant level sensor located in a 1999 Ford Taurus?
The coolant temperature sensor is located near the thermostat housing. The sensor is gray and sits alongside of the temperature sending unit(for your gauge) which is usually brown.
Where is the ect electronic coolant temperature sensor located on a 1995 Taurus sho 3.2 liter?
The ECT (Electronic Coolant Temperature) sensor is located under the intake manifold on the driver's side on a 1995 Taurus SHO 3.2 liter. It is on the cylinder head.
Coolant temperature sender in 1994 Ford Taurus?
If your Ford Taurus is the regular GL model, and not the SHO, then there are 2 different sensors that have to do with coolant/temperature. I have a 1994 Taurus GL 3.0 engine and I am currently working on my engine. The "temperature switch" which controls the gauge in your car is the sensor located to the right and slightly below the thermostat housing on one of the 2 hoses that go into the engine or housing. Mine was an 18mm bolt that had a single plug on the lead. It is smaller than the coolant temperature sensor and looks completely different. It had a round cylinder that bolts into the hose with a flat surface at the end. The "Coolant Temperature Sensor", which sends temperature readings to the engine computer and activates the cooling fan is sometimes found in either that spot or that area. Mine however is found above my thermostat housing on the engine block next to the valve cover. It had a plug port with 2 leads inside a white or grey plastic top. When you take this sensor off, it will have that plastic top with a brass bottom that comes to a point after the threads.
Where is the temperature sensor on 1994 Ford Taurus?
The coolant temperature sensor screws into the bottom of the radiator, and has two wires connected to it which have a quick relese plug....piece of cake
Where is the coolant sensor on a 1999 Ford Taurus 24 valve v6?
AnswerCoolant LEVEL sensor - Located on the bottom of the coolant reservoir.You can see two wire connector protruding towards the fender-side.It is built into the reservoir tank bottom so whole unit gets replaced.See "Related Questions" below for the location of the engine cooling fan sensor and the temperature gauge sending unit/sensor.
Cooling fan switch on 1999 Ford Taurus?
Where is it located? What does it cost? What's it's design purpose? you have to be more specific.The engine coolant temperature (ECT sensor) is covered in the "Related Question" below...
Why would Taurus water temp varies with engine speed?
The temperature of the water will vary on any vehicle with speed, including on the Taurus. The more an engine runs, the higher the water temperature will be in the radiator. If the radiator is overheating, then there could be a malfunction with a temperature sensor, a leaky hose, or damage to the radiator.
What is Coolant capacity for 94 Taurus 3.3 engine?
94 Taurus never had a 3.3L engine, only 3.0L and 3.8L
How do you troubleshoot 1992 Taurus 3.0 temperature gauge?
I have an 1995 Taurus with 3.0 L engine with an erratic temp gage. I found a cure by cleaning the connection where the wire plugs into the sensor on the engine & putting dielectric grease on it.
