I'm not certain that the vehicle came factory-equipped with a trailer wiring harness. HOWEVER - if it does exist look CAREFULLY underneath the rear of the CR-V for the wiring to be tucked up and into the rear area somewhere, perhaps underneath the rear bumper housing.
how do I install a trailer lights to a Honda 1998
The Control Unit and Harness are strongly recommended if you are going to tow anything that requires lights/brake controls. FYI, you don't have to get HONDA control units, most businesses that sell trailers sell various name brands and can do the wiring for you. Anyway, the wiring for the taillights and brakes lights of the vehicle are not strong enough to carry enough power to supply the electrical on a trailer (very dim-could cause a short). The Harness connects a power source (battery) to the trailer wires. The Control Unit is connected to the vehicle wiring as well as the Harness. When you step on the brake pedal, the Control Unit senses it and allows the power to go to the proper wiring on the trailer directly from the power source, therefore you will have brighter lights on the trailer. The same for parking and turn indicators. This is worth the money. I have this set up on my 2003 Odyssey.
If you have a trailer wiring harness it probably has a short in it and is back feeding the circuit when the brakes are applied remove and replace the trailer harness and this should fix the problem.
I'm not certain that the vehicle came factory-equipped with a trailer wiring harness. HOWEVER - if it does exist look CAREFULLY underneath the rear of the CR-V for the wiring to be tucked up and into the rear area somewhere, perhaps underneath the rear bumper housing.
How do you install trailer wiring on a 2009 civic
The wiring harness from the 1999 stereo has a 21 prong plug and the 1995 has a 14 prong plug you can purshase a harness from Honda but it has to be hadrwired to the exsisting wiring but don't screw it up, go to Honda and get a wiring diagram for the both of them to match up the wiring you need to make it work.
Visit auto parts store and order Hoppy 43105 harness. Remove interiorrear panel just above bumper and interior driver side rear quarter panel (where the jack storage is). You will find an unused wiring harness that is taped out of the way. Use this to connect it to the harness and route the wiring into the jack storage area.
The C115 sensor is located right above the wiring harness in a green clip.
Have you checked the fuses? Different circuits have different fuses. It may be your wiring harness, but check the fuses first.
Your problem very well could be the hazard switch. i have a 1994 honda civic too i found whenever i disconnected the hazard switch from the wiring harness my turn signals brake lights and of course hazards do not work. Maybe replace the hazard switch..
You can buy a speaker harness. An adapter that connect the positive and negative from the speaker into the stock harness.
chang the wiring harness inside car.