Where is the IAT sensor location on a 1997 Mazda miata?

Unfortunately, a 1997 Toyota Supra engine and trans would not fit into a 1990 Mazda Miata. The Supra engine and transmission are unable to be mounted correctly within a Miata to make them fit.

The Mazda Miata is a two door convertible sports car. It has been a top selling model for the Mazda motor company since 1989. It is only known as the Miata in North America, in it's home country of Japan it is known as the Mazda Roadster, and in Europe as the MX 5. the Mk1 sold from around 1989 to 1997 the Mk 2 sold from around 1997 to 2005 and the current Mk 3 is still in production today

It is in the center console

The exact location of the speed sensor on a 1997 Honda Accord is on the very top of the transmission. There is a plug in, electronic speed sensor in this location.

1990-1997 = 2,100 pounds 1999-2005 = 2,350 pounds 2006 and on = 2,410 pounds

It does not have a crank shaft sensor.

location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine

Yes. Both are under the car, just before the rear wheel on the passenger side (assuming LHD cars). It is protected by a plastic splash shield. The fuel filter on the 1997 Mazda Miata is located, under the vehicle, on the passenger side, below the seating area, front of the fuel tank. It is mounted on frame in fuel line.

location of the O2 sensor heater on a 1998 GMC 5.7

you can't fix a sensor, you can replace one by removing it and installing the new one...:)

Answer the camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt

no sgc signal. cam position sensor

bank one is the rear head, sensor 2 would be the lower one

location of crankshaft sensor on 1997 Infinity I30 is it on the engine or in the gas tank plz show a pic

Cam shaft sensor is located under the power steering pump on the block

in line with the air filter

There is a problem with the air bag system. Until it is fixed the light will remain on. Take it to a garage for repair.

Assuming we are talking about the Vehicle Speed Sensor (VSS), the 1997 Miata -- (and presumably earlier years) locates this switch on the rear of, or perhaps internal to (I don't know), the speedometer. Examine the schematic for your Instrument Cluster and look for a reed switch labeled Vehicle Speed Sensor. On 1997 Miata, one end is connected to Instrument Cluster connector C-01, terminal 2F, and the other end to ground. Essentially, as the speedometer rotates, the switch opens and closes, shorting terminal 2F to ground, thus creating a series of pulses proportional to the vehicle speed. In the 1997 Miata, this signal is used by the Engine Control Module, the Automatic Transmission (if equipped), the Cruise Control Module (if equipped), and the audio system (if a Type 2 OEM system is installed).

On a 1997 Mercury Cougar XR7, the temperature sensor is located below the air intake. The sensor should be accessible without having to remove any other parts.

the crankshaft sensor is located behind the harmonic balancer on the ft timing cover

Left rear of cylinder head (single wire sensor)

The IAT sensor is in the breather box by The air filter. the sensor goes in the front of the box at the bottom two wires going into it

It should be in the center console between the seats. This is true for my 1990, and since the 1990-1997 Miatas remained virtually unchanged, this should be where it is.

Behind the Timing Belt at the front of the engine. The water pump pulley is the top central pulley on the engine. Removing the Timing Belt is required.

A 1997 Chrysler does not have a MAF sensor. A 1997 Chrysler does not have a MAF sensor.