they are located under intake manifold The #1 sensor is located in the front of the engine and the #2 sensor is located in the back of the engine. Remember to replace the intake gaskets once you replace the sensor/s. The total time it took me to pull the intake and locate the bad sensor was about 6 hours. Hope this helps
Yes, there is a fuel sensor in a 2000 GMC Sierra.
Location of knock sensor 1991 GM sierra 350 2500?
where is knock sensor on a 2001 sierra 5.3 2wd 1500.
Type your answer here... Where IS Cambshaft sensor in 2000 gmc 1500 and what does it do
The knock sensor is located under the Intake Manifold and there is a knock sensor 1/ knock sensor 2 on this model,the 2 is the one in the rear.
knock sensor location is under the intake manifold you have to remove intake their is two knock sensors front and rear
the knock sensors are located in the top of the engine block. The intake has to be removed to get to the sensors.
The knock sensor is on the starter side of the engine. It is abut half way between front and back.
How do you rebuild a differential for a 1981 GMC pickup?
It is screewed in the engine block over by the starter.
On engine block
You have to remove the fuel system including the plenum and fuel rails, there is 2 knock sensors located on the top of the motor, one in the front one in the back
on top of the block. on the left side under the intake manifold.
There are 2 of them, And they are underneith the intake manifold.You will have to remove the intake manifold to get to them.
in the side of the block, above the started
2000 jimmy 4.3ltr v6. were is the o2 sensor bank 1, sensor 3
Knock sensor for the GMC Yukon is beneth the intake manifold mounted to the cam cover.
The 2002 GMC Sierra: temperature sensor is located on the front of the engine. The sensor will be just above the thermostat housing.
On a 2004 GMC Sierra with a 5.3 engine, the knock sensor is locatede under the intake manifold. You have to remove the intake to get to them. There is 2 of them, so it might be better to change them both while it is apart.
There is 2 of them on that engine and there both underneith the intake manifold. YOU MUST REMOVE THE INTAKE to get to them.
The IAT Sensor is attached to the Mass Air Flow Sensor that is attached to your air filter box.
From the videos on YouTube. They are under the intake.
There's 2 of them and there both underneith the intake manifold. You will have to remove the intake to even see them.
That engine has 2 of them and there both are underneith the intake manifold. You can not see are get to them until you remove the intake.
The intake manifold basket was a bad design that was replaced with a better design. Sometimes when this basket leaks, it can get the sensor wet and cause it to corrode. Replace the sensor and manifold