YES it does. It should be close to intake.
Could be vapor lock. The vent on your gas cap may be clogged
did you get the computer to take the error off im talking about those computer that tell u whats the problem with your car.
It could, along with many others causes.
If your newer Nissan still uses the same codes as my 96 a P1110 is a cam positioner sensor malfunction. The problem could also be elsewhere in the cam positioning electronics. Dean
Check the ignition coils and the crank sensor for the Yukon. Either one of these could be bad and cause the problem.
One reason why your 1994 Nissan Altima could be sputtering at an idle is because of your spark plugs. It could also be caused by the idle sensor.
it could be the crank sensor as it is a problem for the altimas.
Numerous things could cause the Nissan Altima to stall. One such thing is the idle control valve, also the exhaust system could cause the engine to stall.
You may find reliable information about Nissan Altima parts at either of the following web sites...www.edmunds.com Used Cars Nissan Altima 2011 Altima or www.insideline.com/nissan/altima/.../2013-nissan-altima-35-sl-full-tes...
my air is cold, and car does not overheat but the fan does not work
The speedometer reaches 160 mph but turning off the sensor could increase speed
A bad crankshaft in a 96 Altima could cause the engine not to start. Depending on the crank damage, the engine could start but not run properly.
there is more then one speed sensor i know there is one in the transmission and one around the front axles and one more not to sure where it could be
the speed sensor, trans. sensor , or the speedometer cable
There could be a few reasons why the radio will not work in a 1999 Nissan Altima. A fuse could of blown or the radio needs to be replaced.
If the 1997 Nissan Altima with an automatic transmission is shifting gears too early, it could be that the shift solenoid for the transmission is faulty. Both the shift solenoid and the speed sensor on the transmission should be checked.
The rubber seal is probably missing or bad. It should be replaced.