Want this question answered?
Your battery is dead if it will not accept a charge. Begin by removing the battery cover. Next, remove the negative and positive cables. Lift the battery out of the motorcycle. Replace it with a new battery and attach the negative and positive cables. Turn on the motorcycle to check that the lights are working and start the motorcycle to make sure that it runs properly. Replace the battery cover.
The item to be plated should be attached to the negative terminal of the battery.
on the bottom of the motorcycle a door open to drop the battery down. loosen the bolt on the side ...but be careful the battery will drop down .
The negative cable is attached to ground. On some cars is attached to the frame and on some it is attached to the engine.
Positive and Negative Terminals.
Positive and Negative Terminals.
You must get a couple of so-called jumper cables. The cables have strong clamps on them and are designed to be clamped to the battery terminals. Attach the black cable to the negative terminals of the motorcycle and car battery first. Then attach the red or positive cable to the positive terminals of the motorcycle and the car battery. In case your motorcycle battery is empty, you can now start the bike from the car battery. Disconnect the cables in reverse order, beginning with the red cable. The motorcycle battery will not be charged much by the car battery but the bike can be jump started by using this method.
1986 700cc SUZUKI INTRUDER how do you get to the battery thank you
Positive and Negative Terminal.
Positive and Negative Terminals.
Connect the positive clip of the battery charger to the positive terminal on the battery. Connect the negative clip of the battery charger to the negative terminal on the battery. Select the charge rate you desire either 2,4, or 6 amp. The newer battery chargers will let you know when it is fully charged.
the main negetive battery lead should run straight to the engine block