answersLogoWhite

0


Best Answer

The OS sensor on a 98 Acura 3.2 TL is located in the exhaust manifold. It constantly monitors the amount of oxygen remaining in the exhaust gases.

User Avatar

Wiki User

โˆ™ 2014-08-23 06:39:43
This answer is:
User Avatar
Study guides

what is door sensor

โžก๏ธ
See all cards
5.0
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
1 Review

Add your answer:

Earn +20 pts
Q: Where is the O2 sensor for 98 acura 3.2 tl?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the o2 sensor on a 98 chev cavalier?

The upstream O2 sensor is mounted in the ehxaust manifold The downstream O2 sensor is mounted in the exhaust pipe after the catalytic converter


How do you change an o2 sensor on a 98 Chevy Cavalier?

don't have the foggiest


Which is the Bank 1 o2 sensor on a 98 Tahoe?

it is the rear sensor bank 1 (the one after the converter)


Where is O2 sensor 98 Ranger 3.0?

It is right on top of the Catalytic Converter.


How many o2 sensor is in a 92 Acura Legend?

There are 2 of them.One on each side of the engine.


98 Mazda 626 idles rough?

I had the same problem on my 98 Mazda 626 and the O2 sensor was faulty.....


Does a 98 expedition Oxygen sensor need codes when replaced?

Just reset your computer after replacing the O2 sensor.


Will an o2 sensor cause your tranny to slip on a 98 durango?

Depends on what type of vehicle you have.


Location of o2 sensor of 98 Chevy astro van?

location of 3 sensor of 97 Chevy astro van?


How do you fix the code PO135 on a 98 Chevy llumina?

O2 sensor heater circuit malfunction (bank 1 sensor 1). You probably have a burned out Bank 1 Sensor 1 O2 sensor. Also check the wiring at the sensor for damage.


How many o2 sensors in 99 tl?

There is one Oxygen sensor on the 99 Acura TL model. Replacing it or repairing the O2 sensor can help the longevity and efficiency of your car and is a fairly simple procedure.


How do you install the o2 sensor for the 98 mercury mystique?

Installing an o2 is very easy. Remove the neg. battery cable. Then disconnect the o2 power connector. Feed the wire through the box end of wrench. Finally, unscrew the o2 sensor.

People also asked