0
There are O2 sensors on the 99 1.6L Protege I don't know about the 1.8L. The 1st one is located at the top of the exhaust manifold where it comes off the engine. The 2nd is located about a foot down the manifold from the 1st. They are not cheap to replace I suggest you know witch one is bad before you replace it.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the o2 sensor for bank1 on 2002 Mazda protege?
It is right under the hood i believe, but not too sure.....
What does code P0140 mean on mazda 1999?
Bad O2 sensor-no activity detected.
Where are the two O2 senors located on a 1999 Mazda Protege 1.6?
One just before the catalytic converter and the other just after the cat converter.
Location of o2 sensor 99 Mazda 626?
where is the location of all o2 sensars in 99 Mazda 626
1999 Mazda B4000 OBD2 diagnostic code P0133 O2 sensor circuit slow responseBank 1 Sensor 1 what does this mean and how do you fix it?
Replace the O2 sensor. Bank 1 sensor 1 means it is the sensor on the side of the number 1 cylinder and before the catalytic converter.
Is the right O2 sensor on a '94 Mazda 626 es with a 2.5 6cyl on the front or rear manifold?
You did not specify which O2 sensor it is. Is it sensor 1 bank 1, sensor 2 bank 2, sensor 2 bank 1, or sensor 1 bank 2. There are four O2 sensors on a mazda 626
Where is the o2 sensor bank 1 located on a 2000 Mazda miata?
The 2000 Mazda Miata O2 sensor bank 1 is located on the firewall in the engine compartment. The sensor can be found on the passenger side of the firewall.
Where is the o2 sensor on a Mitsubishi pejero 1999 3.5 GDI v75w?
Where is the o2 sensor on a Mitsubishi pejero 1999, V6 GDI V75W
How do you replace oxygen sensor in 1993 Mazda protege lx?
If you buy a o2 sensor socket at a parts store, and you have a propane hand torch, and wd40,your halfway done. Stubborn rusted may need heat to remove. disconnect harness on 02 sensor, slide on your socket and break it loose
1999 Mazda millienia Code p0134?
P0134 O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1) check for a disconnected wire connector or melted wires first, then try replacing the O2 sensor, I believe it is the front one on the passenger side. but I could be wrong.
98 Mazda 626 idles rough?
I had the same problem on my 98 Mazda 626 and the O2 sensor was faulty.....
How can you bypass o2 sensor on 1999 Pontiac sunfire?
You can not.
