Car Computers and Sensors
Plymouth Acclaim

Where is the O2 sensor on your 1993 Plymouth Accalim 2.5 liter 4cyl?

202122

Top Answer
User Avatar
Wiki User
Answered
2007-04-03 07:53:31
2007-04-03 07:53:31

On the Exhaust manifond, drivers side

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions




No, just a cam position sensor in the distributor.



if you get the same 3.3 engine, 1993 to a 1995 is all interchangable


Yes it is on passenger side on back side of the intake manifold


It is on the throttle body opposite of where the cables attach.


The sensor will be mounted to the side of the intake manifold below the PCV valve


Yes, and it mounts on the alternator mounting braket, on the passenger side middle.


Follow the upper radiator hose to the engine. Look for a two wire sensor behind the thermostat housing and under the coil. That is it.



Below the throttle body in the exhaust manifold. You can see it when looking from the driver's side.


You can find the crank sensor on the back of your 1993 3.4 liter engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.


its on the rear of the transmission, it cant be replaced by itself, its part of the trans


code 41 -1993 Plymouth voyager - Alternator Circuit


install timing belt on 1993 Plymouth sundance


The crankshaft position sensor is located on the rear of the engine. It is mounted just above the oil pan on the engine block.


I believe there is an oxygen sensor in each of the exhaust manifold outlets ( 2 ) on a 1993 Ford Ranger 4.0 liter


The 1993 Chevy S 10 Blazer 4.3 liter engine temperature sensor can be grounded to the engine block. You can use the temperature sensor retaining bolts to ground the temperature sensor.


The VIN on a 1993 Plymouth is at the lower left of the windshield and on the driver side door jamb.


The 1993 oxygen sensor is the best sensor for a 1993 Honda Accord EX.


http://www.ncttora.com/fsm/1993/engine/92volumeai.pdf


Plymouth Development Corporation was created in 1993.


Where is the O2 sensor on 1993 Toyota Mr2


it is located in the distributor base. look above/right of the oil filter. for a 4 liter engine



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.